BLOTZ B28-WF-110 User manual

Asylum Gates & Asylum Gateway
B28-WF-110 / B28-WF-111
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
A full-colour copy of these instructions can be found on our website: www.blotz.co.uk
Gateway (Both Kits)
The gateway arch is formed from the pieces shown
above.
Glue the eyelets into the uprights as shown.
Attach the asylum arch and leave to dry. Carefully slide the gates into their eyelets. The
eyelets will fit into the gaps left in the sides of the
gates then lower the gates so that the pins fit into
the eyelets.
This will fit snugly within the archway of our
Gettysburg Cemetary Gates building (B28-ACW-001) to
give you an Asylum Gatehouse.

Gateway Surroun (Asylum Gateway only)
Each of the gateway pillars is formed from these four
pieces. Note: one has a lug on the bottom.
Glue these together to form a hollow tube.
Glue the pillars to the base aligning them using the
holes/lugs provided.
Glue the archway to the pillars aligning the uprights
to the centre of the pillars.
Attach the capstones. The lower capstone will slot over
the end of the archway.
The completed gateway.
Wall Sections (Asylum Gateway only)
The base of each wall section is formed from the
pieces shown above.
Glue the two long brickwork sections to the long
coping stones piece using the holes/lugs provided.
Then glue the two small cross-shaped pieces into
the two ends.
For the railings remove the large central section and
the two end pieces from the sprue.
Glue the end pieces to the railings as shown.

Then attach the railings to the base section. Each pillar is formed from thr four long sections and
two cap-stones shown.
Glue the side pieces together so that they form a
hollow tube.
Then stick the two cap-stones on one end so that
they overhang evenly all round.
Finally glue the pillar to one end of the railings as
shown.