BlueSky Mast BST2-K-L104-GND-000 User manual

Grounding Bracket
BST2-P-B205-GND-000
Stainless Steel Cable w/Stakes
BST2-P-C225-GND-000
Grounding Bag
BST2-B-P300-BAG-GND
Surface Wire Grounding Kit —BST2-K-L104-GND-000
DEPLOYMENT INSTRUCTIONS
1. Locate grounding bracket and
attach to the base pole of the
mast.
2. The grounding bracket should be
attached to the middle of the base
pole to provide the best grounding.
3. Locate the grounding cables
and place them at the base
of the mast.
Page 1 of 2
Contents of Surface Wire Grounding Kit
Website: www.blueskymast.com
Email: [e-mail]

DEPLOYMENT INSTRUCTIONS CONTINUED
4. Remove the wing nut from the
post without the Bronze ECLE
connector and attach the ends
of the grounding cables.
5. Connect one end of each of the
grounding cables to the grounding
bracket post an tighten back down
the wing nut.
6. If additional equipment
grounds are required, attach
them to the Bronze ECLE
connector.
Page 2 of 2
PLACEMENT OF GROUNDING CABLES AND STAKES
7. Extend the grounding cables away from the base
pole at 120 degree angles from each other.
8. Position the 1st stake of each cable at the free
end furthest from the base of the mast.
9. Evenly space the remaining stakes of each cable
at an interval of 4.5 ft. from each other.
10. Hammer the stakes into the ground making sure
that the head of each stake contacts the ground.
Website: www.blueskymast.com
Email: [e-mail]