BM PRO ProBoost User manual

ProBoost Install guide
2. mounting
1. location
3. cable size 4. voltage drop calculation
precautions
BMPRO’s ProBoost is a multi-stage DC-to-DC battery charger that enables the charging of a secondary battery using solar panels and/or a
towing vehicle’s 12V electrical system.
The ProBoost blends both solar and auxiliary inputs to ensure there is always a consistent charge to your battery. The ProBoost is available in
two models, the ProBoost25 and the ProBoost40 to suit your charging needs.
https://www.calculator.net/v
oltage-drop-calculator.html
Scan the below QR code to determine
the voltage drop of your wires.
Ensure the vehicle engine is turned off
to prevent any short circuiting during
installation.
Use heat shrinkable tubing on all cables
for insulation to prevent short circuits.
Install the ProBoost in any orientation.
Ensure the location is well-ventilated
with airflow to prevent overheating.
Securely mount the ProBoost to any
strong flat surface, preferably close to the
auxiliary battery.
With cables between 10-8 AWG, BN8
Butt Splice Connectors are
recommended.
5. wiring
1. Disconnect the negative pole of the starter battery.
2. Connect the red cable to the positive pole of the AUX battery.
3. Either connect the black cable to the negative pole of the AUX battery
or connect both AUX battery negative terminals and the ProBoost black
cable to the vehicle chassis ground.
4. Connect the yellow cable to the positive pole of starter battery.
5. Smart alternators: connect the blue cable to the ignition terminal of the
vehicle (usually in the fuse box). If you do not have a smart alternator,
leave the blue cable disconnected.
6. Solar panels: connect the green cable to the positive pole of the solar
panel. Connect the negative terminal of the solar panel to the ProBoost
black cable cable or vehicle chassis ground. If you do not have solar
panels, leave the green cable disconnected.
7. Restore the negative connection of the battery.
TEAM
BMPRO
.COM
Mounting
location
Mounting
location
DOC PART 038643
REV 1.0

6. fusing 7. battery type selection
TEAM
BMPRO
.COM
8. LED charge indicator
The LEDs on the ProBoost will illuminate to indicate the
current charging stage. The flashing LED indicates the
charging source (either alternator or solar). If both the
alternator and solar LEDs are flashing, the charging
source is from both the alternator and solar.
Fuses should be connected in series in circuit. Bolt down fuses
are preferred. Blade type fuses and self-resetting circuit
breakers are not recommended.
Once installed, the battery type must be selected for
the ProBoost to charge correctly. Press the Mode
button until the LED is lit for the correct battery type.
9. LED fault indicator
PROBOOST MANUAL BMPRO SOCIALS
DOC PART 038643
REV 1.0