Victory 4x4 TUNDRA Configuration guide

2ND AND 3RD GEN TUNDRA
BEDFRONT MOLLE PANEL
Thank you for purchasing from Victory 4x4! Checkout our website, victory4x4.com for other great o-road
products. Be sure to rate and review our product online. If you have any questions or are missing parts, please
don’t hesitate to call us at 269-459-8447!
INSTALL INSTRUCTIONS
Please read the mounting instructions below carefully before attempting to install.
Be sure to check out the install video on the product page, if available.

INCLUDED HARDWARE
14x
5/16”-18
Serr. Flange Nut
14x
5/16”-18 X 5/8"
Button Head

INCLUDED PARTS
1x 2x
4x 2x
2x
2022 or Newer
Brackets
07-21 Brackets

1. Start by connecting all three panels using the 5/16”-18 X 5/8” button head
bolts and 5/16”-18 serr. flange nuts. The one with the Victory logo goes in
the middle and the other panels can go on either side. Just make sure that
the slots in the bottom corner are on the outside on both panels. You can
decide whtether you want the middle panel to go under or over the other
two. Now is the time to attach any mounts that you want to use on the
panels because it is dicult once the panels are mounted.
INSTALLATION
2. Next, loosen the two large bolts in the bed of the truck right next to the
cab using a T-55 torx, just enough to be able to slip the mounts under
them. Make sure the mounts go under the washers as well. Be sure to
check the included parts list above for which lower brackets to use for
your year Tundra. Then tighten them partially back up but make sure the
mounts are still able to move. Push the mounts against the front of the
bed for now to get them out of the way.

INSTALLATION
3. Using a T-30 torx, remove the bolts along the top of the bed. If you have a
model older than 2022, you my have to remove the rail and use a hammer
to remove the slide pin in the middle (as shown below) that would prevent
you from bolting it back down flush with the new brackets.
4. Now, using the 90 degree brackets we provide, reinstall the bolts back into
the bed with the brackets. If you have a slide rail, place the brackets behind
it and then re-install with the brackets. Be sure to hold the bracket straight
while you tighten them.

INSTALLATION
5. Aer your brackets are in place, secure the assembled panel to the brackets
in the orientation shown below using the provided button heads and nuts.
Once the panel is loosely secure to the brackets, secure the panel to the
previously installed lower mounts. Aer everything has been assembled
and loosely installed, go through and tighten everything down to finish the
install.
2022 or Newer

INSTALLATION
07-21 Models