BODY BIKE SMART+ Installation guide

QUICK MANUAL
BODY BIKE SMART+
After each workout, wipe the cycle down with tissue paper.
Once a month, we recommend to wipe the side covers and
posts with an oily cloth to protect them from sweat etc.
Only use Vaseline oil. Never use alcohol or chemicals.
If it is necessary to move the cycle, handle it with care and
avoid bumps. Use the handlebars in locked position and
wheel the cycle. DO NOT lift by the saddle or handles.
Front and seat posts are fitted individually to each bike so
DO NOT switch them from one cycle to another.
Tighten the pedals every 2 weeks to prevent them from
getting loose or breaking off. The pedals should always
be screwed on in the direction of the handlebar. Use a
15mm pedal wrench to tighten the pedal. Pedals should be
changed once a year or at least after 1500 hours of cycling.
Inspect the Kevlar®brake pad after the first month and
hereafter every third month. Replace the brake unit before
the Kevlar®brake pad is worn through and reveals the black
rubber. At every inspection the cycle should be vacuum
cleaned inside. Also check that the ribs on the Poly-V belt and
pulley are clean. Polish the flywheel edge with 3M Scotch-
Brite™pad to prevent dirt from collecting on the edge.
Edition 1.2
DAILY USE
PEDALS
INSIDE INSPECTION
To ensure that the cycle is in level, always adjust the rubber
after moving the cycle. Every second year the rubber feet
should be replaced as the rubber hardens and becomes
unable to absorb the impact.
RUBBER FEET
Download and read full instructions on
www.body-bike.com/marketing/manuals

STABILIZERS
x 2 M8x20
READ ME
x 2 Ø8 washer
Torque wrench
Allen 5mm
Tighten to 12Nm
Ribs facing up
Lift here
HANDLEBAR
x 2 M6x10
x 2 Ø6 dual washer
Torque wrench
Allen 5mm
Tighten to 12 Nm
1 ring for tight fit
2 rings for extra tight fit
READ ME
PEDALS
Left pedal (L)
L
R
Right pedal (R)
READ ME
Start mounting
by hand
15mm pedal wrench
Tighten to 45Nm
Lift here