Bolt OFF VEHICLE COUPLER LOCK User manual

BOLT®
Lock
Step 1:
Instructions for Coding the BOLT®Lock to your ignition key:
1.1 Read and remove warning
sticker - remove key from
key chain
1.2
(Insert key - Do not pull up/
down on key while coding)
While maintaining full key
insertion, turn the key
clockwise until it stops
1.3 The lock is now successfully
coded - Cycle Lock 3x to
ensure that the lock was
properly coded
Strap Plate Bolt
1/2”- 20 x
1 3/4”
Pin
1 7/8”
Ball
2 5/16”
Ball
Items:
oFF VEHICLE
CoUPLER LoCK
FoR SPanISH and FREnCH tRanSLatIonS go to:
HttP://www.boLtLoCK.Com/aboUt-StRattEC/boLt-LItERatURE
LoS tRadUCtoRES aL ESPañoL y FRanCéS PUEdEn VISItaR:
HttP://www.boLtLoCK.Com/aboUt-StRattEC/boLt-LItERatURE
PoUR LES tRadUCtIonS En ESPagnoL Et En FRançaIS, aLLEz à:
HttP://www.boLtLoCK.Com/aboUt-StRattEC/boLt-LItERatURE

Step 2: Setting up your Off Vehicle
Coupler Lock
2.1 Select the correct ball size for your
trailer coupler
2.2 Place ball on plate over the nut
2.3 Tighten bolt using a 3/4” wrench
Step 3: Using your Off Vehicle Coupler
Lock
3.1 Place plate with ball attached in your coupler
and latch the coupler
3.2 Place strap over coupler and through
either the forward or rear slots of the plate
(depending on your coupler style)
3.3 Adjust strap height until it is snug with the
coupler, and a set of holes is in line with
the plate
3.4 Place pin through the plate and the strap
3.5 Secure the pin with the BOLT®Lock
3.6 Make sure the BOLT®Lock is fully inserted
4.1 Use your ignition key to unlock when you
need it!
For more information go to:
BOLTLock.com