Bolton Furniture ANNP2971 User manual

REPLACEMENT PARTS
Please do not contact the company purchased from as we can help you faster.
Order replacement parts and hardware at"boltonfurniture.com"
www.boltonfurniture.com
Tool Included
ASSEMBLY INSTRUCTIONS
40"COAT HOOK W/SHELF
. Use of power tool to assemble
this product will invalidate any
claim and damage this product
making it unsafe!!!
. Please assemble on a clean soft
surface to avoid damage.
!
12
11
10
9
8
7
6
5
4
3
2
1
50 minutes
(Not included)
(Included)
Page1 Coat Hook w/Shelf 2020/3/9

Part List- 40" Coat Hook W/Shelf
Identifying the hardware-Identify the hardware using the illustrations below.
www.boltonfurniture.com
A
Page2 Coat Hook w/Shelf 2020/3/9

Step1
Step2
Note: If possible, we recommend that you secure cleat (B) to stud in wall.
Step 3: Position Cleat (B) on wall in desired location where shelf will be hung. Make sure cleat is level.
Step 4: Using Cleat (B) as template, align holes in cleat to studs in wall. Drill 1/8" pilot holes 3/4" deep.
A
C
C
H
01
G
02
M6X60mm
Page3 Coat Hook w/Shelf 2020/3/9

Step 5: Attach French Cleat (B) to Studs in wall in at least 2 locations using wood screws (E )
Step 7: Hang coat hook on cleat
. Secure in 2 places using wood screw (E ).
www.boltonfurniture.com
Step 6: If hole locations do not align with stud in wall, install the EZ Anchor(F) in to drywall by tapping it in to the
predrilled pilot holes up to the thread, and then screwing the EZ Anchor in to the drywall. Attach Cleat (B) using
wood screw (E ) to EZ Anchors. NOTE: Cleat could be secured using combination of Studs and EZ Anchors.
Stud
Wallboard
E
Drywall Drywall Drywall
1
F
2
B
3
Page4 Coat Hook w/Shelf 2020/3/9