
The provided mounting holes
(A) are visible after opening
the oven door on the left and
right frame.
Electrical connection
Electrical connectionElectrical connection
Electrical connection
WARNING:
WARNING:WARNING:
WARNING:
•
The installation to the mains supply must conform
to the local standards and regulations.
Improper connection may cause to an
Do not use multiple sockets or extension cords.
allowed to modify the plug provided with
the appliance. If the plug does not fit properly to
the outlet, let install a proper outlet by an autho
ized specialist.
•If possible, t
he accessibility of the power plug
must be ensured in order to disconnect the
from the power supply in case of an eme
Ensure that your mains power corresponds with
the specifications of the appliance. The specific
tions are printed on the rating label.
Connect the mains cable to a properly installed
and earthed wall outlet.
•
If the plug after installation is not accessible, a
disconnect device with a contact
separation of at least 3 mm must be available to
the relevant safety regulations.
Startup / Operation
Startup / OperationStartup / Operation
Startup / Operation
Information to reduce the environmental effect of
Information to reduce the environmental effect of Information to reduce the environmental effect of
Information to reduce the environmental effect of
cooking
cooking cooking
cooking
(acc. VO (EU) No. 66/2014 appendix I, No. 2)
(acc. VO (EU) No. 66/2014 appendix I, No. 2)(acc. VO (EU) No. 66/2014 appendix I, No. 2)
(acc. VO (EU) No. 66/2014 appendix I, No. 2)
We recommend the use of dark baking molds and
plates, because they conduct the heat better.
The installation to the mains supply must conform
to the local standards and regulations.
Improper connection may cause to an
electric
electric electric
electric
Do not use multiple sockets or extension cords.
allowed to modify the plug provided with
the appliance. If the plug does not fit properly to
the outlet, let install a proper outlet by an autho
he accessibility of the power plug
must be ensured in order to disconnect the
from the power supply in case of an eme
Ensure that your mains power corresponds with
the specifications of the appliance. The specific
tions are printed on the rating label.
Connect the mains cable to a properly installed
If the plug after installation is not accessible, a
disconnect device with a contact
separation of at least 3 mm must be available to
the relevant safety regulations.
Information to reduce the environmental effect of
Information to reduce the environmental effect of Information to reduce the environmental effect of
Information to reduce the environmental effect of
(acc. VO (EU) No. 66/2014 appendix I, No. 2)
(acc. VO (EU) No. 66/2014 appendix I, No. 2)(acc. VO (EU) No. 66/2014 appendix I, No. 2)
(acc. VO (EU) No. 66/2014 appendix I, No. 2)
We recommend the use of dark baking molds and
plates, because they conduct the heat better.
Any unnecessary accessories should be removed
baking chamber before using the appliance.
During cooking, the oven door should remain closed
to avoid unnecessary heat loss.
Only preheat the oven if required by the recipe.
If a selection of cooking time is specified, always use
Use the residual heat by switching back to minimum
temperature shortly before the end of the cooking
Save electricity! If you do not need the oven, switch
off functions such as interior lighting, program, te
perature
Clean the oven after
each application, to keep the
cleaning effort as low as possible.
We recommend the use of biological cleaners.
Information to professional users for disassembly
Information to professional users for disassembly Information to professional users for disassembly
Information to professional users for disassembly
(acc. VO (EU) No. 66/2014 appendix I, No. 2)
(acc. VO (EU) No. 66/2014 appendix I, No. 2)(acc. VO (EU) No. 66/2014 appendix I, No. 2)
(acc. VO (EU) No. 66/2014 appendix I, No. 2)
Oven
OvenOven
Oven
Information for non-
Remove the lamp as described in the manual.
For maintenance purposes, the oven door can be
hang out and reinstalled, for the procedure please
A further disassembly for maintenance purposes is
If you would like to exchange defective components,
please contact our customer service.
Accumulators are not included.
Information for disassembly in terms of recycling,
recovery and disposal at the end of the life of the
appliance
The disassembly of ap
pliances with a gas connection
should only be carried out by a licensed gas and
Any unnecessary accessories should be removed
baking chamber before using the appliance.
During cooking, the oven door should remain closed
to avoid unnecessary heat loss.
Only preheat the oven if required by the recipe.
If a selection of cooking time is specified, always use
Use the residual heat by switching back to minimum
temperature shortly before the end of the cooking
Save electricity! If you do not need the oven, switch
off functions such as interior lighting, program, te
each application, to keep the
cleaning effort as low as possible.
We recommend the use of biological cleaners.
Information to professional users for disassembly
Information to professional users for disassembly Information to professional users for disassembly
Information to professional users for disassembly
(acc. VO (EU) No. 66/2014 appendix I, No. 2)
(acc. VO (EU) No. 66/2014 appendix I, No. 2)(acc. VO (EU) No. 66/2014 appendix I, No. 2)
(acc. VO (EU) No. 66/2014 appendix I, No. 2)
Remove the lamp as described in the manual.
For maintenance purposes, the oven door can be
hang out and reinstalled, for the procedure please
A further disassembly for maintenance purposes is
If you would like to exchange defective components,
please contact our customer service.
Accumulators are not included.
Information for disassembly in terms of recycling,
recovery and disposal at the end of the life of the
pliances with a gas connection
should only be carried out by a licensed gas and