Borroughs Automotive Work Stations User manual

1
Borroughs Document Number: A1-INST-08 Rev: —
Automotive Work Stations
Installation Instructions
3002 N. Burdick Street
Kalamazoo, MI 49004
t: 800-748-0227 f: 269-342-4161
www.borroughs.com
RETAIN THIS MANUAL FOR FUTURE REFERENCE
Read all instructions before proceeding with installation or
drawer loading. Vital product information pertaining to
proper set-up and cautions are included. Failure to follow
these instructions may cause failure which may result in
personal injury or property damage.
——————IMPORTANT——————
PRODUCT LIABILITY INFORMATION

2
Borroughs Document Number: A1-INST-08 Rev: —
LIFT CABINET
(ROTARY IN-BAY / CHALLENGER)
Note: Please refer to M1-INST-01
and M1-INST-09 for instructions on
anchoring and linking cabinets.
Remove drawer from housing by
releasing the safety clips on the
slide profile and then lifting the
drawer as you pull.
Using a steel cutting tool, remove
the 6x12 inch access panel from
the bottom or the rear of the
housing depending on your
installation requirements.
Move the housing to its permanent
location and install anchors or link
to adjacent cabinets.
Route all required utilities through
the access hole into the housing.

3
Borroughs Document Number: A1-INST-08 Rev: —
Note: We recommend placing the
drawer face-down on a pair of 2x4s
while completing steps 5 and 7
Remove mounting plate from
drawer assembly by unscrewing
(4) 1/4-20 hex head nuts and bolts.
Attach mounting plate to the pump
using the appropriate hole pattern
and hardware provided with the
pump.
Reattach mounting plate to the
drawer assembly using hardware
from step 5.
Reinstall drawer into cabinet
housing by inserting the drawer
slide profile into the middle slide
profile and lifting the front as you
close the drawer.
Make all utility hookups based on
lift control manual.
LIFT CABINET
(ROTARY IN-BAY / CHALLENGER)