Bosch Dinion XF LTC 0495/11 User manual

Video | LTC 0495 Series DinionXF Day Night Cameras
LTC 0495 Series DinionXF Day Night
Cameras
www.boschsecurity.com
u15-bit DSP Technology
uHigh sensitivity
uMechanically switching IR filter for IR sensitivity at
night
uXF-Dynamic for unsurpassed wide dynamic range
uBilinx Communication for remote set-up and control
The LTC 0495 High Performance 1/3-inch Digital CCD
Day/Night Camera ensures the highest image quality
possible at any time. Depending on the available light
the camera will automatically switch from color to
monochrome.
A unique combination of 15-bit digital video
processing that enhances sensitivity and XF-Dynamic
which extends the dynamic range provides a sharper,
more detailed image with outstanding accuracy in
color reproduction.
All Dinion cameras are supplied ready to operate.
Simply attach and focus the lens, then connect power.
No tools are required for back focus and power
connection. For especially challenging situations
where fine tuning or special settings are required, the
camera parameters can be individually set using the
control buttons on the side of the camera and On-
screen Display (OSD). The camera automatically
detects the lens type. The Lens Wizard ensures
accurate back-focusing for perfectly sharp pictures at
all times.
Functions
XF-Dynamic
The highly accurate 15-bit digital signal is
automatically processed to optimally capture the
detail in both the high and low light areas of the scene
simultaneously, maximizing the information visible in
the picture.
Bilinx Technology
Bilinx is a bidirectional communication capability
embedded in the video signal of all Bosch Dinion
cameras. Technicians can check status, change camera
settings, and even update firmware from virtually
anywhere along the video cable. Bilinx reduces service
and installation time, provides for more accurate set-
up and adjustment, and improves overall performance.
In addition, Bilinx uses the standard video cable to
transmit alarm and status messages, providing
superior performance without additional installation
steps.
Video Motion Detection
The built-in video motion detector allows you to select
up to four fully programmable areas with individual
thresholds. The global scene change detector
minimizes false alarms caused by sudden lighting

condition changes, such as switching on or off the
indoor or security lighting. When motion is detected
alarms may be displayed in the video signal while the
output relay can be closed in addition to alarm
message transmission on Bilinx.
Auto Black
The automatic black level feature enhances contrast by
compensating for reduced contrast (i.e. glare, fog,
mist).
Default Shutter
The LTC 0495 features a fast, default shutter speed in
sufficient lighting conditions to capture moving
objects. When light levels fall and other adjustments
have been exhausted, the shutter speed reverts to the
standard setting to maintain sensitivity.
Back Light Compensation (BLC)
Offering a fully programmable BLC area of interest,
and a variable BLC level, the camera can be easily set
up for even the most challenging entrance
applications.
Lens Wizard
The Lens Wizard automatically detects the lens type
and helps focus the lens at the maximum opening to
ensure proper focus is maintained throughout the 24-
hour cycle. No special tools or filters are required.
Programmable Modes
Three independent, preprogrammed operating modes
support typical applications, but are fully
programmable for individual situations. Switching
between modes is easy via Bilinx or the external alarm
input.
Day/Night Mode
The Day/Night Mode LTC 0495 provides enhanced
night viewing by increasing the IR sensitivity. The IR
filter can switch from color to monochrome
automatically by either sensing the illumination level or
via the alarm input. The filter can be switched
manually via the alarm input, through the camera
menu, or via the Bilinx coaxial control interface. An
internal through the lens IR detector enhances the
monochrome mode stability, as it prevents reverting to
the color mode when IR illumination is dominant.
SensUp
By increasing the integration time on the CCD up to 10
times, the effective sensitivity is dramatically
enhanced. This is especially useful when relying only
on moonlight for illumination.
Certifications and approvals
Electro Magnetic Compatibility
Emission EN55022 class B, FCC class B part 15
Immunity EN50130-4 Alarm Systems, Part 4
Vibration Camera with 500 gr (1.1 lbs) lens according
to IEC60068-2-27
Safety
LTC 0495/11 and LTC 0495/51: EN60065
LTC 0495/21 and LTC 0495/61: UL6500, cUL CAN/CSA E60065-00
Region Certification
Europe CE Declaration of Conformity
USA FCC Declaration of Conformity
Installation/configuration notes
Dimensions in mm (inches)
Parts included
Quantit
y
Component
1LTC 0495 Series DinionXF Day\Night Camera
1 C/CS – mount conversion ring
1 Spare male 4 – pin lens connector
Lens not included
Technical specifications
Electrical
Model No. Rated Voltage
LTC 0495/11 12 – 28 VAC 45 - 65 Hz
11 – 36 VDC
LTC 0495/21 12 – 28 VAC 45 - 65 Hz
11 – 36 VDC
LTC 0495/51 110 – 240 VAC 45 - 65 Hz
LTC 0495/61 110 – 240 VAC 45 - 65 Hz
Power Consumption 4 W
CCD Type 1/3-inch interline
2 | LTC 0495 Series DinionXF Day Night Cameras

Active Pixels
PAL Model: 752 x 582
NTSC Model 768 x 492
Sensitivity (3200 k)
Sensitivity (full video) 1) 2.4 lux (0.24 fc)
Sensitivity 50 IRE1) 0.59 lux / 0.08 lux (Monochrome mode)
Minimum illumination1) 0.24 lux / 0.038 lux (Monochrome mode)
Minimum Illumination
with Sens Up
0.024 lux / 0.0038 lux (Monochrome
mode)
Horizontal Resolution 540 TVL
Signal-to-Noise Ratio > 50 dB
Video Output 1 Vpp, 75 ohm
Y/C Output Y: 1 Vpp / C: 0.3 Vpp
Synchronization Internal, Line Lock, HV-lock and Genlock
(Burst lock) selectable
Shutter Auto (1/60 (1/50) to 1/500000), fixed,
flickerless, default
Sensitivity up Off, Automatic continuous up to 10x
Auto Black On, Off selectable
Range 32x dynamic range enhancement
Dynamic Noise
Reduction
Auto, Off selectable
Contour Sharpness enhancement level selectable
BLC Off, Area and Level selectable
Gain Auto (maximum level selectable to 28 dB)
or fixed level selectable
Lens Mount CS (max lens protrusion 5 mm, 0.2 inch)
White Balance ATW (2500 - 10000 K), AWB hold,
Manual WB selectable
VMD 4 area, sensitivity selectable
Alarm Output VMD or Bilinx
Alarm Input (TTL) Profile switching, +5 V nominal, +40 VDC
max
Alarm Output Relay max. 30 VAC or +40 VDC, Max 0,5 A
continuous, 10 VA
External Synchronal
Input
75 ohm or High Impedance selectable
Cable Compensation Up to 1000 m (3000 ft) coax without
external amplifiers (automatic set-up in
combination with coaxial communication)
Camera ID 16 character editable string, position
selectable
Lens Types Manual, DC- and Video-Iris auto-detect
with override DC-iris drive: max. 50 mA
continuous
Video-iris: 11.5 ± 0.5 VDC, max 50 mA
continuous
Remote Control Bilinx coaxial communication
1) F/1.2, 89% reflection, SenseUp off
Mechanical
Dimensions (H x W x L) 59 x 67 x 122 mm (2.28 x 2.6 x 4.8 inch)
without lens
Weight 450 g (0.99 lbs) without lens
Tripod Mount Bottom (isolated) and top 1/4-inch
20 UNC
Controls OSD with softkey operation
Environmental
Operating Temperature -20°C to +50°C (-4°F to 122°F)
Storage Temperature -25°C to +70°C (-13°F to +158°F)
Operating Humidity 20% to 93% RH
Storage Humidity up to 98% RH
Ordering information
LTC 0495/11 DinionXF Day Night Camera
1/3-inch, high performance, 540 TVL, PAL, DSP, 12 –
28 VAC/11 – 36 VDC, 50 Hz
Order number LTC0495/11
LTC 0495/21 DinionXF Day Night Camera
1/3-inch, high performance, 540 TVL, NTSC, DSP, 12 –
28 VAC/11 – 36 VDC, 60 Hz
Order number LTC0495/21
LTC 0495/51 DinionXF Day Night Camera
1/3-inch, high performance, 540 TVL, PAL, DSP, 110 –
240 VAC, 50 Hz
Order number LTC0495/51
LTC 0495/61 DinionXF Day Night Camera
1/3-inch, high performance, 540 TVL, NTSC, DSP, 12 –
28 VAC, 60 Hz
Order number LTC0495/61
Accessories
LTC 3364/21 Varifocal Lens IR corrected
1/3-inch, 2.8 – 6 mm, DC-iris, CS-mount F1.4-200, 4-
pin
Order number LTC3364/21
LTC 3764/20 Varifocal Lens IR corrected
1/2-inch, 4 –12 mm, DC-iris, C-mount, F1.2-360, 4-pin
Order number LTC3764/20
3 | LTC 0495 Series DinionXF Day Night Cameras

LTC 3774/30 Varifocal Lens IR corrected
1/2-inch, 10 – 40 mm, DC-iris, C-mount, F1.4-360, 4-
pin
Order number LTC3774/30
LTC 3783/50 Zoom Lens IR corrected
1/2-inch, 8.5 – 85 mm, Video-iris, C-mount F1.6-360, 4-
pin
Order number LTC3783/50
LTC 3793/50 Zoom Lens IR corrected
1/2-inch, 8 – 144 mm, Video-iris, C-mount, F1.6-360, 4-
pin
Order number LTC3793/50
LTC 3664/40 Varifocal Lens IR corrected
1/3-inch, 2.8 – 11 mm, DC-iris, CS-mount F1.4-360, 4-
pin
Order number LTC3664/40
TC120PS Power Supply Unit
Order number TC120PS
TC220PS Power Supply Unit
Order number TC220PS
TC220PSX‑24 Power Supply Unit
Order number TC220PSX-24
TC1334 Power Supply Unit
Order number TC1334
Software Options
VP‑CFGSFT Configuration Software
for cameras using Bilinx, includes VP-USB Adaptor
Order number VP-CFGSFT
4 | LTC 0495 Series DinionXF Day Night Cameras
Represented by:
Americas: Europe, Middle East, Africa: Asia-Pacific: China: America Latina:
Bosch Security Systems, Inc.
130 Perinton Parkway
Fairport, New York, 14450, USA
Phone: [phone]
Fax: [phone]
[email protected]
www.boschsecurity.us
Bosch Security Systems B.V.
P.O. Box 80002
5617 BA Eindhoven, The Netherlands
Phone: + 31 40 2577 284
Fax: [phone]
[email protected]
www.boschsecurity.com
Robert Bosch (SEA) Pte Ltd, Security
Systems
11 Bishan Street 21
Singapore 573943
Phone: [phone]
Fax: [phone]
[email protected]
www.boschsecurity.asia
Bosch (Shanghai) Security Systems Ltd.
201 Building, No. 333 Fuquan Road
North IBP
Changning District, Shanghai
200335 China
Phone [phone]
Fax: [phone]
www.boschsecurity.com.cn
Robert Bosch Ltda Security Systems Division
Via Anhanguera, Km 98
CEP 13065-900
Campinas, Sao Paulo, Brazil
Phone: [phone]
Fax: [phone]
[email protected]
www.boschsecurity.com
© Bosch Security Systems 2013 | Data subject to change without notice
2007154699 | en, V2, 04. Oct 2013