BOSS ILLUMINATION VIPER User manual

www.bia.lighting | [email protected]page 1 / 2
PRODUCT MANUAL
COPYRIGHT BIA ©2020 V03.20
Disclaimer: Please read these warranty
and installation instructions carefully
before installing the product.
BIA products are manufactured
and certied in accordance with all
mandatory Australian Standards.
All products must be installed by a
licensed electrician, in accordance
with relevant Australian Standards.
Technical data and information subject
to changes, visit our website for the
most updated version.
WARRANTY STATEMENT This product is covered by a 5 year replacement warranty.
BIA guarantees this product to be free of defects from the date of purchase for the stated period above. If product fails within the warranty period, BIA will x
or replace the product. This excludes any costs associated with the removal or installation of product. This warranty is subject to the terms and conditions stated
on www.bia.lighting. Failure to comply with installation guidelines will automatically void the warranty. Please retain purchase receipt. For more information on
warranty please visit www.bia.lighting/warranty
BIA reserves the right to change specications and other information, modify products and discontinue items without prior notication.
PRODUCT VARIANTS
Power : 50W
100W
CCT : 3000K
4000K
5000K
Dimming: 0-10V
DALI
PRODUCT SPECIFICATIONS
Input Voltage : 100-277 VAC
Ambient Temperature : -10 to 45°C
Weight : 6kg
VIPER
POLE LIGHT
Must be installed by
a licensed electrician.
Must be installed
in accordance with
relevant Australian
Standards.
IP6560mm
PARTS INCLUDED
8-10m CableLED
Luminaire
ADDITIONAL INFORMATION
1. 0-10V dimmable option available. These cables must be
terminated if not in use.
2. Please ensure luminaire cover is sealed.
3. Installation must be carried out with care to ensure the surface
of the luminaire is not scratched or damaged. Damaged surfaces
will result in material corrosion when exposed under harsh
weather conditions.
4. If cleaning maintenance is required, use a clean microfibre cloth,
slightly dampened with a mild dilution of detergent that is PH
neutral, alcohol free and non-abrasive.

www.bia.lighting | [email protected]page 2 / 2
PRODUCT MANUAL
COPYRIGHT BIA ©2020 V03.20
INSTALLATION INSTRUCTIONS
1. Ensure pole of the correct diametre has been installed/supplied.
2. Feed wiring cable through spigot. Cable should be terminated
within the pole and to the IP rating required.
3. Optional: If installing dimmable version, connect cable within
the cavity of the holder.
4. Place luminare over spigot and slide it all the way in.
5. Tighten the screws to firmly secure luminaire.
Note: If necessary, silicone should be applied to wire entry points
to enforce IP rating.
DIAMENSION DIAGRAM
2
5
4
352mm
300mm
437mm
60mm
L
L
N
N
E
E
2
3
0-10V DALI
+DA+
+DA+
-DA-
-DA-