Boss Snowplow THE SNOW PLOW SNOW PUSHER User manual

Attach blade to TUFFBRACE by Inserting 4 hex bolts (1/4”x3/4”) (A) into the 4 holes in the middle of the
blade and fasten to TUFFBRACE with 4 locknuts (B)
THE SNOW PLOW SNOW PUSHER BOSS EDITION
ASSEMBLY INSTRUCTIONS
3. Insert handle into TUFFBRACE.
4. Drill a 1/4” hole in middle dimple on the backside of
the TUFFBRACE with provided 1/4” Drill Bit (E).
5. Secure handle to TUFFBRACE with 2 screws (3/4”) (C)
Insert Hex Bolt (1/4”x2”) (D) in drilled hole and fasten
with locknut (B).
NOTE: Screw the two self tapping screws
in the dimple sections on the back of the
TUFFBRACE handle.
A
A
A
B
A
B B B
B
A
C
E
DB
C
Insert remaining hex bolt (A) in the top blade hole and fasten to TUFFBRACE with locknut (B).
1.
2.
™

HARDWARE PACK INCLUDES
A. Hex bolts (1/4”x3/4”) x 5
B. Locknut x 6
C. Screws 3/4” x 3
D. Hex Bolt (1/4”x2” x 1
E. 1/4” Drill Bit
D-Grip should be parallel with blade - align by placing shovel on floor, TUFFBRACE side up, before
inserting self tapping screw (3/4”) (C) into the handle.
Final Assembly
C
6.
1. 2.
D-Grip - MSC19961
TUFFBRACE - MSC19980
BLADE(S)
28” - MSC19929
36” - MSC19937
48” - MSC19949
HANDLE ASSEMBLY - MSC19962
HARDWARE PACK - MSC19970