Furniture of America CM3557CH-RT User manual

1. Prepare 8 bolt assemblies by first
inserting a lock washer (#D) onto
the bolt (#A) then a flat washer
(#C) onto that same bolt (#A).
2. Place the table top support panel
(#3) onto the legs (#4), then insert
4 bolt assemblies into each panel.
Secure using the Allen wrench (#E).
1. Turn the legs
face down.
2. Insert a bolt (#F) into the
hole along the side of the
legs (#4), shown below.
Turn right to tighten.
3. Apply the leg support (#5) onto
those bolts (#F), then apply a half
round washer (#G), flat washer (#C),
lock washer (#D), and nut (#H). In
that order. Secure using the wrench.

1. Place the table
tops (#1,2) face
down onto a
protected surface,
then secure by
locking the latches.
2. Place the table top connect panel (#6)
onto the center of the table tops (#1,2).
Prepare 4 bolts assemblies by first inser-
ting a lock washer (#D) onto the bolt (#B)
then a flat washer (#C) onto that same
bolt (#B). Insert the bolts into the panels.
Secure using the Allen wrench (#E).
3. Align the connect rails (#7) to the holes displayed above. Prepare 8 bolt assemblies
by first inserting a lock washer (#D) onto the bolt (#A) then a flat washer (#C) onto
that same bolt (#A). Insert into the holes and secure using the Allen wrench (#E).
1. Place the table top support panel (#3) face down
onto the connect rails (#7) and align the holes.
2. Prepare 8 bolt
assemblies by
first inserting
a lock washer
(#D) onto the
bolt (#A) then
a flat washer
(#C) onto that
same bolt (#A).
Insert a bolt into
each bolt Secure
using the Allen
wrench (#E).
ASSEMBLY IS COMPLETED