Brightz Toss Brightz User manual

Toss Brightz™
Installation Instructions
©Copyright Brightz, Ltd. 2015
Patent Pending
All rights reserved
Step 1 – Install batteries
From the BACK of the battery holder slide the back up toremove the battery cover. Install 3 fresh AA batteries,
observing the correct
polarity (+/-). Replace battery cover. Do not mix old and new batteries and do not mix
alkaline,standard
(carbon-zinc) or rechargeable (ni-cad, ni-mh, etc.) batteries.
Step 2 – Positioning and installing the LED lights around the hole
Turn board over so the back side is facing up and attach LED lights using three (3) screw-in fasteners as shown.
Adhere the battery pack to the board with the attached hook and loop fastener. NOTE: Lights are waterproof
but battery pack is not.
TOP END OF BOARD
Clip
Clip
Clip

Step 3 – Positioning and installing the LED lights around the outside of the board
Attach the LED lights (using provided nails and clips) to the outside of the board (similar to Step 2). See diagram
below for clip placement.
Toss Brightz™ is available in 6 colors: Red, Green, Blue, Gold, Orange, and White
Mix and Match for your next party or team event!
Brightz, Ltd.
8000 Yankee Road, Suite 225, Ottawa Lake, MI 49267
Email: [e-mail]
www.brightz-ltd.com
Important!
Start Here (See Arrow) for Optimal Installation
Begin installation of LED string here and work
counterclockwise around the board.
This allows battery pack to be placed closer to
the bean bag hole. Toss Brightz can then be
turned on/off simply by reaching through the
hole.