Brightz tossbrightz User manual

LATCHES
TOSSBOARD
OPENING
TOSSBOARD
SIDE
6x
6x
38x
4x
2x
2x
2x
2x
STEP 1 – Install Batteries (3AA)
Open latches on the side of the battery pack to access or insert batteries.
STEP 2 – Install Battery Pack
A.
Using 2 screws, attach the clip plate
to either left, right, or top side of
board closest to the opening.
See STEP 4 for possible positions.
CONTENTS:
WARNINGS:
Do not mix old and new batteries and do not mix alkaline, standard (carbon-zinc)
or rechargeable (nicad, ni-mh, etc.) batteries.
Caution: Batteries may explode or leak, and cause burn injury if recharged, disposed of
in fire, mixed with a different battery type, or inserted backwards. Replace all used
batteries at the same time. Clean battery contacts and contacts on the device prior to
installing. Remove batteries if item will not be used for long periods of time. When
battery expires remove promptly.
CHOKING HAZARD
Small parts. Not for children 3 years of age or under.
[e-mail]
419 . 517. 0049
tossbrightz™
INSTRUCTIONS

CABLE
CLIP
TOSSBOARD
OPENING
TOSSBOARD
OPENING
TOP OFBOARD
TOSSBOARD
OPENING
UNDERSIDE OF
TOSS BOARD
STEP 2 – Install Battery Pack
Continued...
STEP 3 – Installing Lights around
Tossboard Opening
STEP 4 – Installing Lights around
Outside of Board
B.
SNAP battery pack into place on clip plate.
RELEASE by pushing top tab of clip plate.
Keeping the board flipped over, attach one of
the 1-foot LED light strings around the opening
using 3 screw-in fasteners as shown.
Orientation of 1-foot LED light string
around the toss board opening.
Thread longer LED light
string through cable clips
and nail consistently
around board as shown
by tick marks( ).
Position Battery Packs as
shown by( ) at any
of the 3 possible places.