Bristan Club DUC HNK C User manual

Fitting Instructions & Contents List
Fitting Instructions & Contents ListFitting Instructions & Contents List
Fitting Instructions & Contents List
Design Utility Kitchen Ranges
Design Utility Kitchen RangesDesign Utility Kitchen Ranges
Design Utility Kitchen Ranges
(Club, Crosshead and Lever)
(Club, Crosshead and Lever)(Club, Crosshead and Lever)
(Club, Crosshead and Lever)
Fitting Instructions & Contents List
Fitting Instructions & Contents ListFitting Instructions & Contents List
Fitting Instructions & Contents List
Please eep these instructions for future reference and request of replacement parts
Please eep these instructions for future reference and request of replacement partsPlease eep these instructions for future reference and request of replacement parts
Please eep these instructions for future reference and request of replacement parts

Introduction
IntroductionIntroduction
Introduction
Thank you for choosing Bristan, the UK’s leading taps and showers expert. We have designed this product with
your enjoy ent in ind. To ensure that it works to its full potential, it needs to be fitted correctly. These fitting
instructions have been created to give you all of the infor ation you need and, if you need any further help, please
do not hesitate to give us a call on 0844 701 6273.
Safety Note
Safety NoteSafety Note
Safety Note
Please read these instruction thoroughly and retain for future use.
All product anufactured and supplied by Bristan are safe provided they are installed correctly, used correctly and
receive regular aintenance in accordance with these instructions.
These fittings need to be installed in accordance with and eet the require ents of the Water Supply (Water
Fittings) Regulations 1999 and Scottish Byelaws 2004.
Water Pressure
Water PressureWater Pressure
Water Pressure
These products are suitable for use at all supply pressures. If installed at low pressure (tank fed), then the
ini u distance fro the outlet of the nozzle to the underside of the cold tank should be approxi ately 2 etres
to ensure adequate perfor ance. The taps should be installed in co pliance with Water Regulations. For further
details contact your Local Water Authority.
Installation
Installation Installation
Installation –
––
– High Nec Taps
High Nec TapsHigh Nec Taps
High Nec Taps
1. Identify all co ponents and check for co pleteness, particularly before arranging fitting.
2. Install the taps (3) to the basin/sink. The backnut (1) and backnut washer (2) are used
Contents
ContentsContents
Contents
1. Backnut x2
2. Backnut Washer x2
3. Body x2
4. Valve x2
5. Handle x2
6. Handle Screw x2
7. Indices x2
2. Install the taps (3) to the basin/sink. The backnut (1) and backnut washer (2) are used
under the basin/sink to secure the tap to the surface of basin/sink.
3. Connect the hot and cold water supplies to the taps.
4. Turn on the water supplies. Open both taps letting the water flow for a few inutes to
check all joints and connections for leaks.
Dec Sin Mixer
Dec Sin MixerDec Sin Mixer
Dec Sin Mixer
1. Identify all co ponents and check for co pleteness, particularly before arranging fitting.
2. Attach the spout into the body (3), secure in place with the grub screw ensuring the spout is able to rotate freely.
3. Fit the ixer to the sink using the backnut washers (2) and backnuts (1)below the surface. Then connect the hot
and cold water supplies to the ixer.
4. Fully open both valves, letting the water run for a few inutes to check all connections for leaks.

Contents
ContentsContents
Contents
1. Backnut x2
2. Backnut Washer x2
3. Body x1
4. Valve x2
5. Handle x2
6. Handle Screw x2
7. Indices x2
Sin Mixer
Sin MixerSin Mixer
Sin Mixer
1. Identify all co ponents and check for co pleteness, particularly before
arranging fitting.
2. Fit the ixer (3) to the sink using the fixing kit (10).
3. Screw in connecting copper tail pipes (11) by hand into base of the ixer and
then connect to the hot and cold supplies.
NOTE:
NOTE: NOTE:
NOTE: A non return valve is supplied, which is designed to prevent back feeding
into the hot ains supply. An additional non return valve (not supplied) will be
required for the cold supply.
4. Fully open both valves, letting it run for a few inutes to check all connections
4. Fully open both valves, letting it run for a few inutes to check all connections
for leaks.
Contents
ContentsContents
Contents
3. Body x1
4. Valve x2
5. Handle x2
6. Handle Screw x2
7. Indices x2
10. Fixing kit x1
11. Tail pipes x2
12. Shrouds x2
16. Grub screw x1
17. Non-Return Valve x1
IRN R001 (DUL / DUC / DUX HNK / SNK DSM C)
IRN R001 (DUL / DUC / DUX HNK / SNK DSM C)IRN R001 (DUL / DUC / DUX HNK / SNK DSM C)
IRN R001 (DUL / DUC / DUX HNK / SNK DSM C)
See text of entry for Installation Require ents or Notes.
IMPORTANT
IMPORTANT IMPORTANT
IMPORTANT -
--
- PLEASE READ
PLEASE READPLEASE READ
PLEASE READ
These fittings need to be installed in accordance with the following Installation Require ents and Notes
These fittings need to be installed in accordance with the following Installation Require ents and Notes These fittings need to be installed in accordance with the following Installation Require ents and Notes
These fittings need to be installed in accordance with the following Installation Require ents and Notes
(IRN) to ensure they eet the require ents of the Water Supply (Water Fittings) Regulations 1999 and the
(IRN) to ensure they eet the require ents of the Water Supply (Water Fittings) Regulations 1999 and the (IRN) to ensure they eet the require ents of the Water Supply (Water Fittings) Regulations 1999 and the
(IRN) to ensure they eet the require ents of the Water Supply (Water Fittings) Regulations 1999 and the
Scottish Byelaws 2004.
Scottish Byelaws 2004.Scottish Byelaws 2004.
Scottish Byelaws 2004.
IRN R006 (DUL / DUC / DUX HNK / SNK / DSM C)
IRN R006 (DUL / DUC / DUX HNK / SNK / DSM C)IRN R006 (DUL / DUC / DUX HNK / SNK / DSM C)
IRN R006 (DUL / DUC / DUX HNK / SNK / DSM C)
This tap or co bination tap asse bly has a Type AUK3 air gap and is therefore for installation in any pre ises to
protect against a backflow risk up to a Fluid Category 5.
IRN R010 (DUL / DUC / DUX SNK / DSM C) Schedule 2
IRN R010 (DUL / DUC / DUX SNK / DSM C) Schedule 2IRN R010 (DUL / DUC / DUX SNK / DSM C) Schedule 2
IRN R010 (DUL / DUC / DUX SNK / DSM C) Schedule 2-
--
-15 (1)
15 (1)15 (1)
15 (1)
Water supplies shall be a reasonably balanced pressures fro a co on source (e.g. hot and cold supplies
both fro the sa e storage or both fro a supply pipe). Where the fitting is supplied fro unbalanced supplies
(e.g. hot and cold supplies fro separate sources) a Listed’ single check valve or so e other no less effective
backflow prevention device shall be fitted i ediately upstrea of both hot and cold water inlets.

Maintenance
MaintenanceMaintenance
Maintenance
If any of the fittings begin to drip:
1. Turn off the water supply.
2. Re ove the indices cap (7) and screw (6), and then re ove the handle (5) by pulling fro
valve (4). The re ove valve (4).
3. Once re oved, carefully clean seating, rubber washer and cera ic disc.
4. Replace all of the above then turn on the water supply.
5. If the proble persists contact our custo er services helpline.
Bristan Guarantee
Bristan GuaranteeBristan Guarantee
Bristan Guarantee
Bristan offers solid guarantees to provide you with co plete peace of ind.
Taps and Mixers
Taps and MixersTaps and Mixers
Taps and Mixers
5 year parts and 1 year labour*. Gold painted and special finishes 3 years parts only.
All subject to proof of purchase.
*Labour provided by an approved Bristan engineer. Guarantee only applies to products with a anufacturing fault. A deferred
pay ent will be necessary in order to secure any visits by our engineers which will be charged if the proble is found not
notnot
not to be a
anufacturing fault. If the fault is found to be down to a anufacturing error, the pay ent will be released and not charged.
This guarantee applies to products purchased within the United Kingdo or Republic of Ireland, but does not apply to products
used co ercially.
The guarantee is only available to original purchasers who have proof of purchase.
The installation ust allow ready access to all products for the purpose of inspection, aintenance or replace ent.
Any part found to be defective during the above guarantee period will be replaced without charge, providing that the product has
been installed in accordance with the instructions, used as intended, and regularly serviced.
Servicing should be carried out at regular intervals of no ore than 12 onths and ore frequently in hard water areas (heavy
This boo let covers all product codes
DUC HNK C / DUX HNK C/ DUL HNK C / DUC DSM C / DUX DSM C / DUL DSM C/
DUC SNK C / DUX SNK C / DUL SNK C
Helpline
HelplineHelpline
Helpline
0844 701 6273
0844 701 62730844 701 6273
0844 701 6273
Bristan Group Limited A Masco Company
Birch Coppice Business Par , Dordon, Tamworth, Staffordshire B78 1SG
Website: www.bristan.com Telephone: [phone] Facsimile: 0844 701 6275
Email: [e-mail]
FI (DU KITCHEN) – REV. D3
Servicing should be carried out at regular intervals of no ore than 12 onths and ore frequently in hard water areas (heavy
li e scale) areas.
In the unlikely event that any proble s are encountered with the product’s perfor ance on installation, you ust obtain
guidance/authorisation fro our Custo er Service Depart ent, and be able to supply proof and date of purchase, before any
re edial action is taken.
The guarantee excludes general wear and tear and da age caused by accident, isuse or neglect, and does not cover the
following:
. Co ponents that are subject to general wear and tear such as filters, seals, ‘O’ rings and washers etc.
· Da age caused by faulty installation
· Da age caused by li e scale or any waterborne debris
· Da age caused by inappropriate cleaning products (see user instructions)
· Da age caused by the use of non-Bristan parts
· The product being used for a purpose other than intended by the anufacturer.
In the interests of continuous product i prove ent Bristan reserves the right to alter specification as necessary.
If your product is out of its guarantee period, or you would like to extend the guarantee, then please see our extended warranty
offer.

Check out our full range of Kitchen Products
Kitchen Sinks
Stainless Steel Kitchen Sinks
Granite Composite Kitchen Sinks
Glass Kitchen Sinks
Ceramic Kitchen Sinks
Franke Kitchen Sinks
Kitchen Taps
Contemporary Kitchen Taps
Traditional Kitchen Taps
Franke Kitchen Taps
Pull out Rinser Kitchen Taps
Instant Boiling Water Taps
Insinkerator Waste Disposal Units