Bronco Heated Grip User manual

Heated Grip
The Installation Guide
*Please check each component is included in the package before you go through.
Check all componets
Control Box - 1 PC Clamp.Top - 1 PC Clamp.Bot - 1 PC 3M Tape - 1 PC
Heat Grip - 1 PAIR ConnectorWire - 1 SET Hex.Screw - 2 PCS
SelfTap.Screw - 4 PCS
Thumb Heater - 1 SET
V 1.2
* Damage can occur due to the wrong installation or incorrect wiring.
If you are unsure please ask your local dealer for assistance.
Wiring Connect Guide
<*Fuse>
_Postitive Input DC12 V
_Ground wire / to vehicle body
<Thumb Heater>
* Damage can occur due to the wrong or inappropriate assembling of the Control Unit.
If you are unsure please ask your local dealer for assistance.
Control Box Assembling
Screw on Handle-Bar Attach to body / surface
< OR >
Turn back for operation instruction.
<Connector Wire>
<Thumb Heater Wire>
* To avoid insufficient voltage regulation or potential damage and to avoid Battery
drain it is beneficial to wire the grips to shut off when power supply to vehicle is turned off.

Heated Grip
The Operation Instruction
Switch On
Press the ON-Button for 2 seconds and then release, the blue light will flash.
Increase Heated Level
After the blue light flash, repeat the same action on pressing On-Button.
The green light will flash and the tempertaure will increase.
Startup the Heated Function V 1.1
Increase Temperature Level
Simply press the ON-Button and then release,
the indicator light will flash to the next level.
Decrease Temperature Level
Simply Press the OFF-Button and then release,
the indicator light will flash back to the previous level.
Adjust the Temperature
Switch Off the heated function
Simply press the OFF-Button and hold for 2 secs,
the first level (blue flash) will be off.
The heated function will be successfuly switched off.
Switch Off the Function
0
25
50
75
100
5 10 15 20 25 300
˚C
minutes
40
45
50 55 55 60
50
60
65 70 70 70
60
80 85
95 95 100
70
95
105 110 110 110
Level Indicator
*Measured under 25˚C
*Tolerance +/- 5˚C
Temperature Graph
Turn back for installation instruction.