Brookstone BK-650 User manual

The BROOKSTONE® trademarks, names and logos are owned by BKST Brand Holdings LLC. ©2019. All rights reserved.
Manufactured, marketed and distributed by (Cozzia USA LLC) under license.
Installat
BK-650
ion Manual

Brookstone BK-650.
Brookstone
BK-650 Assembly Instructions
Open box 1 and remove all contents. Remove the packing materials. Take the chair out of box. Collect all
the accessories and put them aside.
2
Locate the two clips on the support lugs of the chair base. Take them off and put aside the chair base.
3
BK-650 arrives in 2 boxes.
1
BK-650
4
Footrest (Box 2 of 2)
2
2
Base & Backrest (Box 1 of 2)
1
BK-650

Connect wires in footrest. Connect footrest wire connectors and screw the caps tight. Then connect the air
hose.
Caution: Match the connectors and aline the white points before you connect them.
7
Connect footrest to base. Move the footrest close to the chair. Engage the link rod with the footrest joint, then
insert the bolt and lock with the cotter pin.
6
Locate the bolt and cotter pin on the footrest link rod. Take them off and put aside the chair base.
4
Open box 2. Take out footrest and remove the cable tie from the link rod.
5
Locate the bolt and cotter pin

Fully connect the footrest to the base. Hang the footrest on the support lugs of the chair base and lock with
the two clips.
8Place the remote control into the holder.
10
Turn on the chair. Connect the chair to a power supply and turn on the power switch. The chair will now be
ready to start.
11
Zip the zippersbetween seat padand footrest cushion.Get rid of the zipper pullerafter the zipper been
zip up.
9