Brookstone Mach IX User manual

The BROOKSTONE® trademarks, names and logos are owned by BKST Brand Holdings LLC. ©2019. All rights reserved.
Manufactured, marketed and distributed by (Cozzia USA LLC) under license.
Installation Manual

Brookstone BK-750/MACH IX.
Brookstone
MACH IX Assembly Instructions
Open box 1 and remove all contents. Remove the packing materials. Take the chair out of the box.
Collect all the accessories and put them aside.
2
Remove the cotter pins and bolts from the chair base. Locate the two cotter pins and bolts on
3
MACH IX arrives in 2 boxes.
1
Locate the cotter pin and bolts

Connect wires in footrest. Connect footrest wire connector and screw the caps tight.
then connect the air hose.
Caution: After the wire connector have been connected the cap must be screwed tight.
6
Fully connect the footrest to the base. Move the footrest closer to the chair. Engage the joints of the
footrest and base. Lift footrest up to align the holes on the joints, then insert the bolt and lock it with cotter pin
(that you had set aside).
7
Open box 2. Take out footrest and remove the cotter pin and bolt and put aside the chair base.
4
Connect footrest to base. Move the footrest close to the chair. Engage the link rod with the footrest
joint, then insert the bolt and lock with the cotter pin.
5
Locate the link rod
Locate the cotter pin and bolt

Place the remote control into the holder.
9
Turn on the chair. Connect the chair to a power supply and turn on the power switch. The chair will now
be ready to start.
10
Zip the zippers between seat pad and base, zip the zipper between seat pad and footrest cushion.
8
Remote control inside the white box