Buffalo Tools GUCMBLS User manual

ITEM # GUCMBLS UTILITY CEILING BIKE LIFT
ASSEMBLY INSTRUCTIONS
DO NOT OVERLOAD! Max Weight Capacity is 44 lbs.
WARNING
IF THERE IS ANY QUESTION ABOUT A CONDITION BEING SAFE OR
UNSAFE, DO NOT USE THIS PRODUCT!
If you experience a problem, have questions or need parts for this product,
call Customer Service at 1-636-532-9888, Monday - Friday, 8 AM - 4 PM
Central Time. A copy of the sales receipt is required. KEEP THIS MANUAL,
SALES RECEIPT & APPLICABLE WARRANTY FOR FUTURE
REFERENCE.
WARNING
Do not support any item other than the intended product use. This is not a toy -
keep out of reach of children. Serious injury can occur if this item is misused.
Excessive weight will cause the pulley to grind, become hard to operate, and
may fray the rope, leading to possibe failure. When calculating the weight of the
bike, include all bags and accessories that might be attached when lifted.
Thread the nylon rope through the pulley system before mounting to ceiling. Start
by threading the rope through the clutch brake device as shown. Follow the thread
route (A - F). Be sure the hooks at (B) and (E) face inward. Thread the end of the
rope through the center hole in the bracket (F). Tie a double knot to secure the end.
A
B
CD
E
F
ATTENTION

This unit is designed to hold ONE bike only. Check that the handle bar and seat are
securely attached to bike. Do not install near electrical outlets, or where human traffic may occur.
ATTENTION
TOOLS REQUIRED
8'-10' ladder
Drill with 3/16" drill bit
Tape measure
Stud finder
Pencil
Wood screws (included)
ASSEMBLY
1) A solid 2" x 4" or larger wood ceiling joist is
required to mount your Bicycle hoist.
2) Determine that you have sufficient clearance.
Measure the distance from the center bar stem
to the end of the handle grip, then add 5" for
clearance of the side wall.
3) Attach Bicycle hoist to the wide side of a 2" x 4".
Use four wood screws in the outer holes on each
rail. Measurement "A” and “B” will determine the
location of the front and back hook.
4) The hoist and board assembly can be attached
to the ceiling joist using 1 /4" x 4" lag bolts with flat
washers (not included). NOTE: It is recommended that all screw holes
be pre-drilled using appropriate size bit.
5) Mount the tie down cleat to the wall. The tie
down cleat must be attached to a solid wood
wall stud. Mount the cleat at a comfortable
height. (approx. 4 foot). Trim excess rope when
the installation is complete. DO NOT trim rope
when hoist is in the elevated position. Lower
hoist to bike height and trim leaving about
three foot addition. rope.
6) Knot and heat seal ends to prevent fraying.