
3BUNDUAWN OWNER'S MANUAL • BUNDUTEC |
Our Annex follows the same product guidelines – ease of use.
It offers a private entry to your tent and keeps off the rain.It
has openings on each side at the top which, due to its nature,
cannot be permanently closed. The side panel used to enclose
it is a basic design that offers privacy and ventilation.It was
also designed to be easy to use and remove and does not offer
any luxurious trimmings, but rather a straightforward design
with utility in mind. The Annex comes in a standard size and a
custom size for longer BunduTops. Please note that - it can’t be
manufactured smaller than our standard size.
PLEASE NOTE that when using it for the rst time the canvas
can be stiff.
It gets coated with various resins to ensure its longevity and UV
qualities, so when rst operating the canvas has no “memory”
of how to fold. After a couple of uses, the canvas will evolve a
“memory” of how to fold and the folding will become neater
and easier as time passes. The initial folding process will seem
stiff but with time it will ease into its shape and fold neatly.
INCLUDES
You Will Receive:
• 1 x Long Rope Guide Extrusion
• 2 x Short Rope Guide Extrusion
• 2 x Rods
• 1 x Round Tube
• 1 x Added Room Roof
• Side Panel Optional
PROS & CONS
Pros
• The Annex offers shade, keeps off rain and offers a
private entry to your tent when utilising the side panel.
Cons
• It absolutely cannot be closed entirely where the top of
the Annex goes under the tent awning. There will be a
small opening.
HOW TOS
Step 1:
Mount the long Rope Guide Extrusion on the edge on TOP of
the BunduTop, not the side. The Annex will slide into this slot.
Step 2:
Mount the two short Rope Guide Extrusions on the sides of the
BunduTop, one to each side. When open the rods will slide into
the guides.
Step 3:
Slide the Annex into the top long Rope Guide. Knot each end so
that it will stay in place and cut off any extra length rope. You
can glue the rope as well as an extra safety measure against the
knot untying. Unzip the bag and unroll the canvas.
Step 4:
Lift the BunduTop until it is about half way open. This is to assist
with inserting the rods – it keeps the mass of canvas out of your
way and makes the process easier.
Step 5:
Fit the Rods into the holes on the Tube, and then slide them
into the Rope Guide on the sides.
Step 6:
Open your BunduTop completely. You can now t the Side
Panel to the Annex if necessary.