Bunn MHG Quick reference guide

MHG GRINDER
USE & CARE INSTRUCTIONS
STEP 1 STEP 2 STEP 3 STEP 4
Place a paper filter into the
brew funnel. The filter must
not be folded over or tilted
to one side. Insert the fun-
nel into the funnel rails and
push until it stops.
Momentarily press and re-
lease the GRIND button. The
grinding action will stop au-
tomatically after the preset
amount of ground coffee is
dispensed into the funnel.
Pressing the STOP button
will terminate a grind.
Visually inspect the hop-
pers for an ample supply of
whole bean coffee.
STEP 5
Remove the funnel from the
grinder and level the bed of
grounds by gently shaking.
The loaded funnel is now
ready for use in any com-
mercial drip coffee brewer
according to the manu-
facturer’s instructions.
39480.0000A 10/06 ©2006 Bunn-O-Matic Corporation
Choose the batch size and
side of grinder to use. It is
not necessary to select a
size on the brewer.
COFFEE GRINDING

STEP 2 STEP 3STEP 1
Clean all exterior surfaces
using a damp cloth rinsed
in any mild, nonabrasive,
liquid detergent.
STEP 5
Remove the hopper lid from
the hopper.
STEP 4
Remove the funnel with fil-
ter and discard any remain-
ing coffee grounds.
STEP 6 STEP 7
Remove the hoppers by
sliding all the way forward.
39480 101206
MHG GRINDER
USE & CARE INSTRUCTIONS
Clean and sanitize the hop-
pers and lids. Care should
be taken not to scratch the
hoppers with any abrasive
material.
Replace the hoppers and
fill with fresh whole bean
coffee. Replace the hopper
lids.
Empty all beans from
hopper(s). Plug in the grind-
er, place funnel with filter
into funnel rails. Press and
release the GRIND button.
Run a few cycles until all
coffee in the grind chamber
is dispensed and disconnect
the grinder from the power
source.
CLEANING
NOTE:Bunn-O-Maticrecom-
mendsthe3 stepmethodfor
cleaning and sanitizing the
server. The 3 step method
consists of hot soapy water
using an approved deter-
gent, a fresh water rinse,
and an aqueous sanitizing
solution using an approved
non-chlorine sanitizer.