Burlington chaplin r12 chr User manual

B
1 - 5
INSTALLATION INSTRUCTIONS
The radiator can be installed in three different heating configurations; connected to a central heating
system, fitted with a summer electric heating kit as an electric radiator, or as a dual source connected
to a central heating system and with a summer electric heating kit fitted.
PLEASE NOTE: THE CHAPLIN RADIATORS ARE MADE FROM STEEL AND WHEN CONNECTED TO
CENTRAL HEATING SYSTEMS SHOULD ONLY BE USED ON CLOSED SYSTEMS CONTAINING A RUST
INHIBITOR.
- review instructions carefully before installation
- installation should be completed by a suitably qualified person
- please dispose of packaging in a responsible manner
POSITION:
The radiator, if intended to be heated with the summer electric heating kit, can be installed in the Zone 2
area (see Fig below), but the electrical connection box must be outside the Zone 2 area.
Zone 1 Zone 2
Zone 0
225cm
Zone 1
60cm
Zone 1 Zone 2
225cm
60cm
Zone 1
Zone 0
Zone 2
60cm
60cm
Zone 0
(1) Side view, bath (2) Top view (3) Side view, shower
PLEASE NOTE:
●This product can only be used at PN≤1MPa (10Kg/cm, 10Bar). It should only be filled with a water
mixture containing a rust inhibitor, and at a temperature below 100°C (or 212°F). See table below
for installation requirements.
●If the temperature exceeds 48°C (or 120°F), please install a warning sign near the product to avoid
burning or scalding accidents.
0°C ≤t≤100°C
●If the product is not used for a period during which ambient temperature drops below 5°C (or 41°F),
please drain the water out of the radiator to avoid oxidization.
●For prolonged usage and safe operation please check product at regular intervals.
°C
Water mixture
containing a
rust inhibitor
AFTER CARE ...
The Chaplin radiators are made from steel with chrome plating, and should not be cleaned with
corrosive or scouring cleaning agents.
Chaplin R12 CHR

B
2 - 5
Ø8mm
Tools required:
Parts supplied:
Installation position is determined by installer.
1
ST4.8 * 45mm
12x
12x
2x
1x
Ø8mm
23

B
3 - 5
Parts required:
2x 2x
The diagrams of control valve and the connecting pipe as shown above are for reference only, and
should be purchased separately.
Heated with the central heating system
After installation ...
●Use a screwdriver to open the air vent,
open the inlet valve and let the water rush
into the radiator. Check all connections for
leaks.
●Once water overflows from the air vent,
there is no air in the tube, use a screwdriver
to close the air vent. Turn on the outlet valve
and the radiator is ready for use.
45
6

B
4 - 5
Parts required:
Connect to the electric supply via a fused spur. Then
check for leaks. At all times follow the installation
instructions supplied with the Summer Electric Heating
kit. All electric work must be done by a suitably qualified
person.
4
The diagram of the summer electric heating kit as shown above is for reference only, and
can be purchased separately.
Heated with the summer electric heating kit only
5
6
If the radiator is to be used for electric heating only ( not
connected to a central heating system ), then seal the
bottom inlet / outlet nipples with the blanking plugs.
Fill the radiator approximately 90% with a water mixture.
containing a rust inhibitor – failure to do this will lead to
leaking as the radiator rusts from the inside. Filling with
more than 90% liquid will lead to leaking as the water
mixture expands as it heats up.
After installation ...
●Use a screwdriver to open the air vent, heating
the liquid inside radiator till summer heating kit
stop working, once no liquid flowing out from the
air vent, use a screwdriver to close the air vent,
then the radiator is ready for use!
1x
Fill water
Water mixture volume (90% full ) ：
R12 CHR : 3.1 liters

B
5 - 5
Parts required:
Connect to the electric supply via a fused spur. Then check for leaks. At all times follow the installation
instructions supplied with the Summer Electric Heating kit. All electric work must be done by a suitably
qualified person.
Dual source connect to central heating system and with a summer
electricheating kit
2x 2x
The diagrams of control valve, the connecting pipe and the summer electric heating kit as shown above are
for reference only, and should be purchased separately.
If this radiator used as a dual source connected to central heating system and with a summer
electric heating kit fitted:
●While use central heating system, power supply must be shut off, and release the air in radiator
as described in page 3.
●While use summer electric heating kit only, turn off the inlet and outlet valves, and make sure the
liquid in the radiator is approximately 90% - failure to do this will lead to leaking as radiator rusts
from the inside, more than 90% liquid will lead to leaking as liquid expands as it heats up. And
release the air in radiator as described in page 4.
1x