Burntech TFS 33 User manual

Arch Installation Instructions
Arch Installation Instructions
for models TFS/OFS 33 /39 /44 /49 /63
for models TFS/OFS 33 /39 /44 /49 /63
These instructions are for the installation of the BURNTech
Arches only. See instructions that came with your unit for
complete Fireplace Installation Instructions.
Step 1
Assemble your fireplace as per the instructions supplied with
it, up until before the last tier of wall.
Step 2
Prior to completing last row of side walls, saw cut 3-1/4”to 3-
3/8” off the front of each of both side walls as shown in Fig.1.
Step 3
Apply mortar to all mating surfaces ofArch and place into cut
opening. Level as necessary.
NOTE: Since the Arch reduces the effective opening height
by 4 inches, you may want to obtain a Height Extension Kit to
compensate for the difference (see Figure 3).
REV 10 FEB 2014
FIGURE 2 Apply mortar
Arch
3 3/4"
CUT
FIGURE 1
CUT
3-1/4” TO
3-3/8”

Step 4
Make sure adequate amount of mortar is applied underneath
and behind Lintel front piece as shown in Figure 4.
Continue assembling your fireplace as per the instructions
supplied with your unit.
Customer Service:
Most parts and accessories may be purchased from your
dealer. For additional Parts and accessories please call
Burntech® Fireplace Solutions Monday thru Friday 9 AM to
4 PM (Pacific Standard Time) at [phone] or Fax your
order to [phone].
You may also visit our website at:
WWW.BURNTECH.COM
A Height Extension Kit
may be added
FIGURE 3
T-Bar
Apply mortar
FIGURE 4
Lintel
A
B
D
C
3"
MODEL AB CD
TFS/OFS 33 37" 8" 4" 3-1/2"
TFS/OFS 39 43" 8" 4" 3-1/2"
TFS/OFS 44 48"
8" 4"
3-1/2"
TFS/OFS 49
53"
8" 4"
3-1/2"
TFS/OFS 63 67"
8" 4"
3-1/2"