BushBaby nestegg User manual

FOR YOU AND YOUR CHILD’S SAFETY PLEASE READ
THE FOLLOWING INSTRUCTIONS CAREFULLY.
Congratulations on purchasing your new bushbaby nestegg the most
innovative child cot available. nestegg has been designed to be light
to transport, easy to put up and give maximum child comfort.
Please be very careful when opening your nestegg. The cot is made
using ‘sprung steel hoops’ which are under tension when packed and
can open out with force. Do not use nestegg on a surface above oor level.
Never leave your child unattended at any time when
using bushbaby nestegg if side entrance is open.
WARNINGS
For the comfort of your child please ensure the surface
on which you wish to place your nestegg is free from
uneven and sharp objects.
The nestegg is only ready for your child, once the mattress
has been inserted below the sleep sheet in the base.
This product is made from ame retardant fabric but
should be kept away from re and other heat sources.
The product may burn if left in contact with a direct
ame source.
PLEASE SEE OTHER SIDE FOR INSTRUCTIONS ON HOW TO PACK YOUR NESTEGG AWAY
Bushbaby® PO Box 61, Stockport, Cheshire, SK3 0AP
Tel. [phone] Fax. [phone] [e-mail] www.bush-baby.com
Additional or replacement parts should only be obtained directly from Bushbaby or via a recommended retailer.
For more information please call : [phone]
To inate:
Open the air valve and allow to inate. Zip into base of nestegg through
the sleep sheet found around the inside of the nestegg. Once fully inated
tighten the valve, extra air can be added if necessary.
To deate the mattress:
Undo the air valve and roll the mattress from the opposite end, this may
be easier done on the oor by kneeling on it and squeezing the air out as
you go. When all the air is squeezed out tighten the air valve to stop it
re-inating. Fold the mattress into four and place in the zip bag provided.
MATTRESS INSTRUCTIONS
nestegg®

YOU WILL NEED TO REMOVE THE MATTRESS BEFORE BEGINNING THE PROCESS.
IMPORTANT, PLEASE READ THESE INSTRUCTIONS.
There is only one way to fold a nestegg correctly. Please study these instructions carefully.
If you force the metal frame you will damage the nest egg.
Close all zips and turn the
nestegg vertical, with the
base facing you.
Hold the metal either side of
the cross-over pulling the
metal ribs together.
Put your foot on the base.
Fold the top cross-over down
towards the oor. Ensuring
the metal does not kink.
Bend down and keep hold
of the cross-over in your
right hand.
Push the cross-over away from you
in a straight line for 40-50cm until
the metal loops start to fold.
Continue to push the
cross-over away and gather in
the loops with your left hand.
The left side will drop at
underneath the righthand
side.
Finally shape the nestegg
into a round shape and
place inside the bag.
8.7.
6.5.
4.
3.2.1.
➟
➟
➟
➟
➟
➟
➟
➟
➟ ➟
➟
nestegg®