C.P. Electronics ELTD1 User manual
Warning. This device works at mains potential. Be sure to take care when
working with electricity.
1. Make sure the load is connected and in working order.
2. Isolate the mains supply to the circuit at the main distribution
board.
3. The unit can be installed in any standard DIN rail consumer unit or
enclosure.
4. Wire the ELTD1 as in the diagram below.
5. Connect the controller via the terminal block. Live supply to the L
terminal, Neutral supply to the N terminal and the load to the NC
terminal. When using the ELT-REL relay unit, connect to the NO
terminal. Loop from the L terminal to the COM terminal.
6. Apply power—the NORMAL lamp will light up.
The ELTD1 emergency lighting test switch is designed to test the function
of emergency luminaires. A push button switch is used to interrupt the
supply to the luminaires for a pre-programmed period of time. At the end of
the time period the supply to the luminaires is automatically re-instated.
The result is that there is no risk of depleting the batteries in the emergen-
cy fitting.
Four pre-programmed test intervals are available:
• 10 minutes
• 30 minutes
• 1 hour
• 3 hours
The unit will power up with the NORMAL lamp illuminated—the supply will
be connected to the output.
Push the test button to select the 10 minute test interval. Push again to
select the next test interval—the supply will be disconnected from the out-
put for the duration of the test.
To cancel a test, repeatedly press the button until the NORMAL lamp illu-
minates.
Installation
Overview
Emergency Lighting Test Switch
Product Guide
ELTD1
Ref: #WD078 Issue 6
LOAD
3 Amp incandescent lighting
3 Amp fluorescent lighting
3 Amp compact fluorescent lighting
3 Amp low energy lighting
3 Amp low voltage lighting (switch primary of transformer)
Fluorescent lighting (max 3 fittings recommended)
For fluorescent lighting total power factor correction capacitance must not exceed 15μF
SUPPLY VOLTAGE 220-240 Volts AC 50 Hz
TIMING PERIOD 10 minutes, 1 hour, 3 hours
FIXING METHOD DIN rail
TERMINAL CAPACITY2.5mm2
MATERIAL Noryl, self extinguishing
TYPE Class 2
TEMPERATURE -10°C to 35°C
CONFORMITY EMC-2014/30/EU
LVD-2014/35/EU
For further compliance information visit
www.cpelectronics.co.uk/compliance
Specification
C.P. Electronics Ltd
Brent Crescent
London
NW10 7XR
United Kingdom
Tel: + 44 (0) 333 900 0671
Fax: + 44 (0) 333 900 0674
www.cpelectronics.co.uk
enquiry@cpelectronics.co.uk
IMPORTANT NOTICE!
This device should be installed by a
qualified electrician in accordance with
the latest edition of the IEE wiring
regulations.
Due to our policy of continual product improvement CP Electronics reserves the right to alter the specification of this product without prior notice.
Other C.P. Electronics Switch manuals
