CAEB USA custom MOUNTAINPRESS 550TPL User manual

MOUNTAINPRESS 550TPL
USA custom version
After-delivery assembly instructions
Apply to:
MP 550TPL custom USA
P0018.DOC.026_R00

INSTRUCTIONS
Aim
Assembly the machine after delivery in a compact case
Tools required
N.1 offset hexagon key wrench metric size 5 mm
N.2 open end wrench metric size 10 mm
N.2 open end wrench metric size 22 mm
N.1 plier
Warning
Read carefully the instructions below
Procedure
1
Couple the drawbar to its
supporting element as
shown in picture. Fasten the
nut well.
2
Remove the side panel
shown in picture. The
control box connector has to
be plugged in here.

3
Take the electric plug
connected to the control box
and insert it through the two
loops shown in picture.
4
The cable has to pass
through the two cable ties
shown in the picture.
5
Place the cable in the C-
shaped element and lock in
in position by means of the
split pin provided. Ply one
end of the split pin in order
to secure the cable position.
6
Plug in the two electric
connectors.
7
See OP 2
Fasten the cable ties and
place the side panel back in
position.

8
Remove the screw and nut
shown in the picture (and
the one on the opposite
side) and align the mounting
hole of the safety bar.
9
Fix the safety bar by placing
the removed screws and
nuts.
10
See user manual §6.1.1
Set the wheels in the
standard position.
11
See user manual §6.4
Place the net roll in its
compartment.