
Ca l Te s t E l e c t r o n i c s
Cal Test Electronics
Cal Test Electronics warrants this product for normal use and operation within
specification for a period of one (1) year from the date of shipment (accessories
and manual not included).
In exercising its warranty, Cal Test Electronics, at its option, will either repair or
replace any assembly returned within the warranty period. However, this will be
done only if the product is determined by Cal Test Electronics’ examination to be
defective because of workmanship or materials, and the defect is not caused by
misuse, neglect, accident, abnormal conditions of operation, or damaged by at-
tempted repair or modifications by non-authorized facility.
The customer will be responsible for the transportation and insurance charges for
the return of products. Cal Test Electronics will return all products under warranty
with transportation charges prepaid. (Continental U.S. only.)
This warranty replaces all other warranties, expressed or implied, including, but
not limited to, any implied warranty of merchantability, fitness, or adequacy for any
particular purpose or use. Cal Test Electronics shall not be liable for any special,
incidental or consequential damages, whether in contract or otherwise.
Warranty
This electronic product is subject to disposal and recycling regulations
that vary by country and region. Many countries prohibit the disposal
of waste electronics equipment in standard waste receptacles.
R o H S
CO M P L I A N T
2011/65/EU
Made in Taiwan
Max. Operating Temp . . . . . . . . . . -20° to +80° C
Humidity . . . . . . . . . . . . . . . . . . . . 85% RH or less (at 35° C)
*Rating applies with Cap. Without Cap, 1000 V CAT II
Definitions:
Measurement Category I (CAT I) is for measurements performed on circuits not directly connected to mains.
Measurement Category II (CAT II) is for measurements performed on circuits directly connected to the low
voltage installation. Examples are on household appliances, portable tools and similar equipment.
Measurement Category III (CAT III) is for measurements performed in the building installation. Examples are
measurements on distribution boards, circuit-breakers, wiring in fixed installation, and equipment for industrial
use.
Pollution Degree 2 refers to an operation environment where normally only dry non-conductive pollution
occurs. Temporary conductivity caused by condensation must be expected.
Low Voltage Directive
(LVD) 2014/35/EU
EN 61010-031:2015
Specifications [EC Declaration of Conformity]
WARNING.The measurement category of a combination probe and clip is the lower
of the two.
Itm. Description Voltage Range Current Max.
1. Silicone eads 1000 V CAT III / 600 V CAT IV 10A
2. Probes *1000 V CAT III / 600 V CAT IV 10A
3. Alligator Clips 300 V CAT II 5A
Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.