Cal Test Electronics CT2696C User manual

Cal Test Electronics
CT2696C
General Purpose Handheld DMM it w/Right-
Angle Plugs
Cleaning
Use the following guidelines:
• Clean only the exteriors of any probe, cable or adapter. Use a soft cotton cloth
moistened with a mild detergent and water solution. Do not allow any portion
of the part to be submerged at any time.
• Dry the probe, cable or adapter thoroughly before attempting to make any voltage
measurement.
• Do not subject the products to solvents or solvent fumes as these can cause
deterioration of the body, cables and/or dielectrics.
Cal Test Electronics, Inc.
22820 Savi Ranch Pkwy.
Yorba Linda, CA 92887-4610
USA
Tel : [phone]
Fax : [phone]
E-mail : [e-mail]
Web : www.caltestelectronics.com
CT2696C_UserManual_r01
Downloaded from Arrow.com.

Cal Test Electronics
Cal Test Electronics
© 2016 Cal Test Electronics. All rights reserved.
Cal Test Electronics products are covered by US and foreign patents, issued and
pending. Information in this publication supersedes all earlier versions.
Specification subject to change without notice.
22820 Savi Ranch Pkwy.
Yorba Linda, California 92887
For product information, sales, service and technical support:
• Call: 714-221-9330
• Email: [e-mail]
• Worldwide: http://www.caltestelectronics.com
1. Silicone Leads, 150cm (60”), Black CT3753-150-0 1
1. Silicone Leads, 150cm (60”), Red CT3753-150-2 1
2. Probe, Fix Tip, 3900 Series, Black CT3974-0 1
2. Probe, Fix Tip, 3900 Series, Red CT3974-2 1
3. Ex-Lg Alligator Clip, Black CT3251-0 1
3. Ex-Lg Alligator Clip, Red CT3251-2 1
4. Adapter, 6mm Spade, Black CT2553-0 1
4. Adapter, 6mm Spade, Red CT2553-2 1
5. Sprung Hook, 3900 Series, Black CT3946-0 1
5. Sprung Hook, 3900 Series, Red CT3946-2 1
Itm. Description Model Quantity
it Components
2.
2.
1.
3.
(Probe Caps)
5.
4.
Downloaded from Arrow.com.Downloaded from Arrow.com.

Cal Test Electronics
Cal Test Electronics
Cal Test Electronics warrants this product for normal use and operation within
specification for a period of one (1) year from the date of shipment (accessories
and manual not included).
In exercising its warranty, Cal Test Electronics, at its option, will either repair or
replace any assembly returned within the warranty period. However, this will be
done only if the product is determined by Cal Test Electronics’ examination to be
defective because of workmanship or materials, and the defect is not caused by
misuse, neglect, accident, abnormal conditions of operation, or damaged by at-
tempted repair or modifications by non-authorized facility.
The customer will be responsible for the transportation and insurance charges for
the return of products. Cal Test Electronics will return all products under warranty
with transportation charges prepaid. (Continental U.S. only.)
This warranty replaces all other warranties, expressed or implied, including, but
not limited to, any implied warranty of merchantability, fitness, or adequacy for any
particular purpose or use. Cal Test Electronics shall not be liable for any special,
incidental or consequential damages, whether in contract or otherwise.
Warranty
This electronic product is subject to disposal and recycling regulations
that vary by country and region. Many countries prohibit the disposal
of waste electronics equipment in standard waste receptacles.
R o H S
C O M P L I A N T
2 0 1 1 / 6 5 / E U
Made in Taiwan
Max. Operating Temp . . . . . . . . . . -20° to +80° C
Humidity . . . . . . . . . . . . . . . . . . . . 85% RH or less (at 35° C)
*Rating applies with Cap. Without Cap, 1000 V CAT II
Definitions:
Measurement Category 0 (CAT 0) : circuits that are not directly connected to mains. Examples are automobiles
or other battery operated circuits or devices.
Measurement Category II (CAT II) : applicable to circuits connected directly to socket outlets of the low-volt-
age mains. Examples are consumer appliances, po er tools, or the consumer side of socket outlets.
Typical short circuit currents: <10 kA
Measurement Category III (CAT III) : applicable to circuits connected to the distribution part of a building’s
low-voltage mains. Examples are po er distribution boards, solar cell po er assemblies, circuit boxes, circuit
breakers, s itches and industrial equipment.
Typical short circuit currents: >10 kA
Measurement Category IV (CAT IV) : applicable to circuits connected at the source of the building’s low-voltage
mains. Examples are measurements on devices installed before the main fuse or circuit breaker in a building.
Typical short circuit currents: >50 kA
Pollution Degree 2 refers to an operation environment where normally only dry non-conductive pollution
occurs. Temporary conductivity caused by condensation must be expected.
Low Voltage Directive
(LVD) 2014/35/EU
EN 61010-031:2015
Specifications [EC Declaration of Conformity]
WARNING.The measurement category of a combination probe and clip is the lower
of the two.
Itm. Description Voltage Range Current Max.
1. Silicone Leads 1000 V CAT III / 600 V CAT IV 10 A
2. Probes *1000 V CAT III / 600 V CAT IV 10 A
3. Ex-Lg Alligator Clips 1000 V CAT III / 600 V CAT IV 36 A
4. Adapter, 6mm Spade <30 VAC / <60 VDC 36 A
5. Sprung Hooks 300 V CAT II 3 A
Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.

Cal Test Electronics
Cal Test Electronics
To avoid personal injury and to prevent fire or damage to the cables or adapter or any
product connected to them, review and comply with the following safety precautions.
Use of these cables or adapters or test instrument they are connected to in a manner
not specified by the manufacturers may impair protection mechanisms.
Connect to properly grounded instruments. Use only with test instruments having
their input connected to earth ground. Do not connect the cables or adapter’s
ground shells to any point which is at a potential other than earth ground.
Do not disconnect the cable or adapters from instrument during measurement.
Connect the cable or adapters to the measurement instrument before connecting to
the test circuit.
Do not apply to their inputs any potential that exceeds the maximum rating of the
lead or adapters.
Do not use if any part is damaged. All maintenance should be referred to a quali-
fied service personnel only.
Do not use in wet or explosive atmospheres.
For indoor use only.
General Safety Information
To avoid Personal Injury and Product Damage:
Basic Operation
Model CT2696C is a general purpose accessory kit for use with most all handheld
digital multimeters.
WARNING.Warning statements identify conditions or practices that could result in
injury or loss of life.
Symbols and Terms
CAUTION.Caution statements identify conditions or practices that could result in
damage to this product or other property.
These terms may appear in this manual:
The following symbols may appear on the product:
D
ANGER
High Voltage
A
TTENTION
Refer to Manual
D
OUBLE
I
NSULATION
Protective
(E
ARTH
) T
ERMINAL
Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.