Calspas CAL METRO User manual

CAL METRO™
CONTACT IN FORMATION
For customer service, please contact your
authorized dealer immediately. If you need
additional information and/or assistance,
contact:
Lloyd’s Material Supply Company, Inc.
Customer Service Department
1462 East Ninth Street
Pomona, CA 91766.
Toll Free: 1-800-CAL-SPAS
Fax: [phone]
LTR20091088
6/30/2023

The drawing below represents the nished product after assembly.
1

Once you open your Cal Metro™ 2- Tier Steps you will
nd the separate pieces ready for assembly.
Two long, straight pieces when joined will
form your Cal Metro steps. You will need a
Phillips-head screwdriver to complete the
assembly.
Phillips-head
screwdriver
the screws can be attached to the support
beams with the Phillips head screwdriver. The
screw holes are already drilled into the bench
supports.
2
Support wedge
Support beam

The step support beams are made to
t into slots on the bottom of the
bench
(see illustration below)
Base supports
3

Begin to attach the supports underneath the top part of the 2-tier
bench .
(see illustration below)
Use the screws to secure the support beams to the
base underneath the bench.
Screws
Base supports
4

Be sure to secure the rst support beam to the bottom of the steps
5

be sure to secure both sides of the support beam that
ts into the center support base
Center
support base
6
Support beam

be sure to secure both sides of the support beam
that ts into the center support base
7

As the supports are secured, they will look like
the illustration below
8

9

10

11

12
The bench wedges to support the beams at
the bottom will t at the base of the steps.
(please see picture below)
Support Wedge

13
The bench wedges to support the beams at
the bottom will t at the base of the steps.
(please see picture below)
support wedge ts here
use screws to secure
Bottom view of the Cal Metro™ steps

14

15

16
The second (lower level) of the steps are shown here with
pictures of the screws and where they should be placed.
Place screws here
screws

17
Repeat the process for the 2nd tier of the steps and tighten all
screws. Your results should look like the illustration below.

Your completed bench will look like the illustration below when nished
Please be sure that screws are tightened for a secure t.
18

CONTACT IN FORMATION
For customer service, please contact your
authorized dealer immediately. If you need
additional information and/or assistance,
contact:
Lloyd’s Material Supply Company, Inc.
Customer Service Department
1462 East Ninth Street
Pomona, CA 91766.
Toll Free: 1-800-CAL-SPAS
Fax: [phone]
CAL METRO™
LTR20091088
6/30/2023