Cambridge Casual CC-320617 User manual

EXTENDABLE DINING TABLE
CC-320617
ASSEMBLY INSTRUCTIONS

1
GENERAL INFORMATION & TIPS
1. Please read the assembly instructions prior to assembling the table.
2. To avoid damage, assemble the table on a non-abrasive surface such as carpet.
3. Make sure all bolts tightly fastened before the table is used.
4. This table is not for commercial use.
Please make sure you have all parts before beginning assembly. Please wait until all steps
are completed before tightening bolts.
Allen wrench. For tightening all bolts.
It's included in hardware list.
PARTS AND HARDWARE LIST
D. 2 3/4" Bolt
B. Leg frame C. Cross bar
QTY: 1 pc QTY: 2 pcs QTY: 1 pc
A. Table top
E. 1 1/2" bolt F. Spring Washer
QTY: 8 pcs + 1 QTY: 4 pcs + 1
G. WasherH. Umbrella hole plug
QTY: 8 pcs + 1 QTY: 1 set
QTY: 8 pcs + 1

2
METAL PIN
FOLDABLE LEAVES
E
D
G
F
OUTER UMBRELLA HOLE
UMBRELLA HOLE COVER
-Put the table (A) face down on a flat non-abrasive surface.
-Attach the leg frames (B) into table top (A) and secure using washers (G), spring washers (F) and
2 3/4" bolts (D) as diagram shown.
** DO NOT TIGHTEN ALL BOLTS YET.
-Next, attach the cross bar (C) into pre-assembled leg frames (B) and insert 1 1/2" bolts (E) into
predrilled holes as shown.
-Make sure all parts are correctly connected and tighten all bolts completely using allen wrench.
-Turn the table upright.
E
C
B
B
A
STEP 1
STEP 2
To extend :
-Pull the table top from each end.
-Unfold the leaves.
-Push both ends of table top together. Make sure metal pins
are matched with holes as diagram shown.
STEP 3
Put the umbrella hole plug (H) into hole of table top (A) as diagram shown.
H
ASSEMBLY INSTRUCTIONS