Cambridge Casual Heaton IT-370218T User manual

TEAK STORAGE BOX
IT-370218T
ASSEMBLY INSTRUCTIONS
CUSTOMER SERVICE INFORMATION
Please do not return to the store. If any pieces are missing call our toll free number at
1-888-287-4275 from 9:00 am to 5.00 pm CST (Monday to Friday) for replacement parts.
For faster service, have the style number handy when calling.

1
GENERAL INFORMATION & TIPS
1. Please read the assembly instructions prior to assembling the storage box.
2. To avoid damage, assemble the chair on a non-abrasive surface such as carpet.
3. Make sure all bolts tightly fastened before the storage box is used.
4. This storage box is not for commercial use.
Please make sure you have all parts before beginning assembly. Please wait until all steps
are completed before tightening bolts.
1. A Phillips screwdriver (not included).
- for tightening all bolts and screws.
2. A Rubber mallet (not included).
- for tapping wooden cap.
3. A Wrench (included).
- for tightening all lid nut.
PARTS AND HARDWARE LIST
D. Back frame
A2. Left side frame B. Top frame C. Front frame
Qty: 1 pc
A1. Right side frame
E. Slatted base F. 5/8" Screw G. 1 3/4" Bolt
Qty: 1 pc Qty: 1 pc Qty: 1 pc
Qty: 1 pc Qty: 1 pc Qty: 9 pcs + 1 Qty: 8 pcs + 1
H. Wooden cap
Qty: 8 pcs + 1
I. 16 mm screw
Qty: 8 pcs + 1
J. Lid Support
Qty: 2 pcs
K. Lid nut
Qty: 2 pcs
TOOLS REQUIRED

F
ASSEMBLY INSTRUCTIONS
2
STEP 3
STEP 1
THE STORAGE BOX IS NOW READY FOR USE.
Attach the right and left side frames (A1 & A2) to the
front and back frame (C & D), position as figure. Insert
1 3/4" bolts (G) to secure frames (A1 & A2), as shown.
**NOTE: Installation right side frame (A1) and left
side frame (A2) do not reverse.
** Do not tighten the bolts yet.
STEP 4
STEP 2
G
A2
D
C
G
A1
H
E
H
1
I
2
K
J
F
Put the slatted base (E) to the assembly from step 1, as shown.
Tighten all bolts using screwdriver, tapping the wooden caps (H)
to cover bolts head using rubber mallet.
Attach the top frame (B) to the
assembly from step 2, secure with
5/8" screws (F) using screwdriver,
position as shown.
Then, attach lid support (J) into top
frame (B), secure with 16 mm
screws (I), as shown (figure 1).
Next, attach lid nut (K) and lid
bottom (J) to the right and left
frame (A1 & A2), using wrench
(figure 2).
B
J
A1
The upper side slope frame.
D
Figure.