Brackets 1 with tabs, 1 without tabs
Bracket
Template
3
For installation on stone, brick or stucco, use the
mounting bracket template to mark where holes need
to go. Then drill 3/16”holes and insert anchors, give
them a tap with a hammer or mallet.
5
Mount the bracket to the wall next to your door
using the screws and anchor kit included.
6
Attach both wires from the original doorbell button
to the terminals on the back of the Video Doorbell.
7
Line up the video doorbell on the bracket and slide
up or down until secure. It will click into place
4
Thread the doorbell wires through the center of the
square opening in the mounting bracket with tabs.
8
POWER ON! Flip that circuit breaker, run back to the
doorbell and wait until the LED ring repeatedly
flashes 3 times. It may take up to 1.5 minutes for
the unit to activate.
If doorbell is on side wall, stack the two brackets included
with the tabbed bracket on top to create a 30° angle
SIDE WALL MOUNTING
TABS intentionally
removed
There – you did it! It should be look’in good.
Good stuff to know
Tap Snapshot icon to save image
to camera roll or gallery
Tap to Record to MicroSD card
(pre-installed)
Tap and hold Microphone icon
to talk, or shout out, (sound comes
thru video doorbell’s speaker)
Tap Settings icon from home page
to access Advanced Settings and
Customizing Features.
The default admin password is 123456
Tap to turn audio ON or OFF
in Live View Mode
Ring, ring, your video doorbell is
calling! (press Phone icon to answer)
Smart motion detection push
notication alerts
Tap to RETURN icon to go
back to main page
Tap to EVENT icon to review
recorded les
NOTE: It does not matter
which wire connects to which
terminal of the Video doorbell.
AMZ30DB
OFF
ON
Ring-a-ling?
Did you hear it ring when tested?
Cam Sees
9
Device Setup
Download the Cam Sees App and
open it. Use the Set Up Wizard to connect to your Wi-Fi
network and follow the steps to finish installation.
Sweet! You’re almost there.
NOTE: Screen shots and icons may vary due to continuous updates to App and software development.
FREE APP
DOWNLOAD
CameronCameras.com
For detailed installation and setup, please refer to the
Model AMZ30DB complete User’s Guide available on our website.
Cameron Cares
If you need assistance, please contact
CUSTOMER SUPPORT
at 1-800-275-9381
App Download & Wi-Fi Connection
A E
F
G
B
C
D
E
From your smart device or tablet, DOWNLOAD
and INSTALL the free Cam Sees App.
After power is turned on, allow the camera up to 90
seconds to start up and the LED Ring ashes 3 times.
Now, LAUNCH the Cam Sees App
and the Setup Wizard will appear.
Tap to start the Wizard
and then tap Add Device.At the next screen enter a new password/
security code twice. Tap SAVE.
Select your home network
from the menu, and then enter your
home network’s Wireless Password.
If you get an error, make sure to enter
the correct password and repeat.
Tap the PLAY icon or preview
picture for live video.
Tap New Device and the unit will
start searching.
NOTE: If the mobile device’s
bluetooth is not turned on, a message
will appear requesting to have the
bluetooth setting turned on.
TIP: Remember to write down
your new password and save it
somewhere safe and easy for
you to access.
SAVE
Modify Security Code
New Security Code
Conrm Security Code
Cam Sees
Next
For New Device ?
For new Device
Please turn on Bluetooth
New Device
For Existing Device ?
Cancel Search Again
FO LD
FO LD
FO LD
FO LD
