CANDOR CW-33 User manual

THERMOELECTRIC
WINE COOLER
Model No: CW-33

1
Operation Manual
Index
I. General Safety Precautions…………........................2
II. Technical Data………………………..........................3
III. Illustrated Structure…………………….......................3
IV. Electric Principle Diagram…………………………….4
V. Operation ……………………………..……………….. 4
VI. Particular Precautions…………………..…………….5
VII. Maintenance…………………………..………………5
VIII. Troubleshooting………………………..……………...6

2
I. GENERAL SAFETY PRECAUTIONS
●After removing the wine cooler from the package, make sure it is in
good condition. In case of doubt, do not use it and contact an
authorized service center.
●Plastic bags, nails, etc. Should be kept out of the reaching of
children. Read the operation manual carefully and check that the
rating data on the rating nameplate corresponds to your power
supply.
●This wine cooler can only be used in the use of which it was
designed. The manufacturer will not respond for any damage due
to improper use or repairs made by unqualified personnel.
●Before cleaning the cooler, make sure it is unplugged. Never clean
the unit with an acid preparation, medical, dilution, gasoline, oil or
any other kind of chemical substance that could damage the wine
cooler.
●Repair should only be made by authorized service centers.
●Caution
1. To reduce the risk of fire, when the fuse of the power board
was broken, replace only with same type fuse by authorize d
service centers.
2. Free standing installation only
3. Do not use extension cords.
4. Danger: Risk of child entrapment. Before throwing away your old
wine cooler, you must note: a. Take off the door; b. Leave the
shelves in place, so that children may not easily climb inside.

3
This appliance can be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have
been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved.
Children shall not play with the appliance. Cleaning and user
maintenance shall not be made by children without supervision.
This appliance is intended to be used in household and similar
applications such as
–staff kitchen areas in shops, offices and other working
environments;
–farm houses and by clients in hotels, motels and other residential
type environments;
–bed and breakfast type environments;
–catering and similar non-retail applications.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in order to
avoid a hazard.
Do not store explosive substances such as aerosol cans with a
flammable propellant in this appliance.

4
II. TECHNICAL DATA
* based on standard test results for 24 hours. Actual energy
consumption will depend on how the appliance is used and where it
is locate.
·** This appliance is intended to be used at an ambient temperature
between 10 °C and 32°C.
Type
CW-33
Category
10
Energy efficiency class
B
Annual Energy Consumption, AEc *
164kWh/y
Volume (liter)
33L
design temperature
17°C
Climate Class **
SN( Temperate broad)
N( Temperate)
Rated Noise
37 dB(A)
Material
Case
Iron
Door
Glass
Unit Dimension
(W×H×D)(mm)
345*490*470
Packaging Dimension(W×H×D)(mm)
385*525*495
Net Weight (Kg)
11.5
Gross Weight (Kg)
12.6
Energy Consumption
0.447 kWh/24h (25°C)
Temperature Range
11-18(±1) °C
Rated Voltage
220-240V
Rated Frequency
50HZ
Input power
70W
Protection class
I

5
III. ILLUSTRATED STRUCTURE
1. Light 2. Fan Mask 3. Shelf 4. Foot
5. Hinge Cover 6. Glass Door 7. Magnetic Door Seal
8. Light button 9.C/F button 10. LCD display
11. Set temp up button 12. Set temp down button
IV. ELECTRIC PRINCIPLE DIAGRAM

6
V. OPERATION OF WINE COOLER
●The ideal working temperature is under the room temperature of
25°C, under this condition the appliance can be adjusted in the
range of 11°C—18°C(± 1°C).
●The temperature inside the unit can be cooled to 15°C after 1.5
hours when it is empty load, and 1.5~2.5 hours more will reach to
your favorite (setting) temperature.
●When the power is connected, cooling system starts to work.
●The temp you want can be setted by touching “ ” and “ ”
with your finger. When the inside temperature higher than the
setting point Cooling system will be work normally. When the inside
temperature lower than the setting point, cooling system stop
working. And the inside temperature will be rise. When it raises
above the set point, Cooling System starts to work again, the cellar
enters into cooling circles.
●If you want to display the temperature in Fahrenheit (F) or Celsius
(C), you can change it by touching °C/°F button.
●The Light can be turned OFF or ON by touching

7
NOTE:
After you setting the temperature, the LCD display will return to show
the temperature in the cooler, but it could turn to the point that you
have set gradually.
VI. PARTICULAR PRECAUTIONS
●In order to function at its potential, this wine cooler needs to be
placed on flat floor, with 2cm spaces at each side and 10cm at the
backside.
●Use the adjustable (iron case) to place the cooler fully horizontal.
●Avoid direct sunshine and carry high temperature.
●Hot food should be cooled down before placing in the cooler .
Do not mix uncooked food with cooked food.
●Do not place heavy articles on the top of the cooler.
VII. MAINTENANCE
●Shut off power supply before cleaning cabinet.
●Take out wines and shelves, and then clean the cabinet with soda
water first and with clean water last.
●Do not use soap or detergent for the cabinet.
●Clean the wine cooler regularly.
VIII. TROUBLESHOOTING

8
IX.Recycling and Disposal
This appliance is marked with the classification symbol for
Waste Electrical and Electronic Equipment. This marking
indicates that this product should not be disposed of
with household waste.
Electrical and electronic appliances must be delivered to an
Ecocenter complying with EU Directive 2012/19 / EU to be
dismantled and recycled because, because they contain
dangerous substances, they pose a threat to the environment and
human health.For more information, contact your local or regional
authority.
Symptoms
Possible cause
Solutions
No cooling
Plug not put in
Low voltage
Fuse broken
Put in the plug
Ensure normal voltage
Change fuse
Not cold
enough
temperature
inside
The wine cooler is
placed too near
heat source;
Bad ventilation;
Fans don’t work;
The door is not
closed tightly or
opened too
frequently or for too
long time;
Keep the wine cooler away from sunshine or
other heat source;
Place the wine cooler in the area with good
ventilation and keep things away from the
fans;
Check whether the plug is connected or
change the fan;
Close the door tightly and don’t open the
door too frequently or for too long time.
Peculiar smell
inside wine
cooler
Check whether
there is any sour
inside
Wrap the source or take it out
Inside light
flash
Set temperature
higher than inner
temperature;
The automatic
defrost function start
to work
Adjust the adjustor
Normal function. No repair needed
Frost on the
cold sink。
Too much humidity
or too low
temperature inside
the case
Output the plug, stop the power, and defrost by
hand, Connect power again when the ice
thaws

9
X. GUARANTEE
This product has a warranty period of two years, from the date of
purchase.
The guarantee covers malfunctions and malfunctions of the
appliance provided that it is used in the context for which it is
intended and which is contained in this instruction and use manual.
In order for the guarantee to be valid, it is necessary to present the
proof of purchase (receipt / invoice), that the appliance is complete
and with its accessories.
The warranty does not cover damage caused by normal wear and
tear, lack of maintenance, neglect or improper installation, or
incorrect use (shocks, failure to observe energy recommendations,
storage or use, etc.).
Also excluded from warranty are the consequent damages caused
by the use of accessories or parts not original or unsuitable for the
purpose of disassembling and transforming the appliance.
Regardless of the guarantee granted, Brico Depot will continue to be
responsible for the defects of contract compliance and hidden
problems under the Guarantees Law (Decree-Law no. 67/2003,
amended by Decree-Law no. 84/2008).