Car and Driver CAD-6057 User manual

User Manual
CAD-6057
We’re here to help!
Call us at this number
[phone]
Or email us
[email protected]

2
FCC Statement
This device complies with part 15ofthe FCC rules. Operation is
subject tothe following two conditions (1) this device may notcause
harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
This equipment hasbeen tested and found tocomply with the limits
for a Class B digital device, pursuant toPart 15ofthe FCC Rules.
These limits are designed toprovide reasonable protection against
harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference toradio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference toradio or
television reception, which can be determined by turning the
equipment off and on, the user is encouragetry tocorrect the
interference by one ormore of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
the equipment.

3
This equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 20cm between the
radiator & your body.
Important Safety Instructions
1. SAVE THESE INSTRUCTIONS- This manual contains important
safety and operating instructions for CAD6057.
2. Before using CAD4057, read all instructions and cautionary
markings on Vehicle Battery Adapters.
3. Do not expose charger to rain, moisture, or snow.
4. When replacing an old fuse, use a new fuse with the same type
and rating to prevent fire or electric shock.
5. Make sure the cord is located where it will not be stepped on,
tripped over, or otherwise subjected to damage or stress.
6. Do not operate the charger if it has a damaged cord or power
connector. Replace it immediately.
7. Do not operate charger if it has received a sharp blow, been
dropped, or otherwise damaged in any way. Take it to a qualified
serviceperson.
8. Do not disassemble the charger; take it to a qualified
serviceperson when service or repair is required. Incorrect
reassembly may result in a risk of electric shock or fire.
9. To reduce risk of electric shock, unplug the charger before
attempting any maintenance or cleaning. Turning off controls will
not reduce this risk.

4

5
1Introduction
Specifications
•Frequency: 2.402 ~ 2.480 GHz
•Working Current: 45mA (Max)
•Stand-by Current: 25mA (Max)
•Effective Range:5m
•Frequency: 88MHz – 108.0MHZ
•Input: DC12-24V
•Output: DC5V2.4A + PD30W
•Power: 122wmax
Features
•Stream music from your Bluetooth enabled device toa
car’s stereo via FMsignal
•LED display that shows the car’s voltage when
connected topower
•Allows you to answer calls and speak hands-free
•Built-in microphone forphone calls
•Two charging ports: USB and Type C ports
•Two 12V charging sockets
•Siri/Google activation
2Getting Started
Power-on
The device turns on automatically when plugged into a car
cigarette lighter.
Frequency and Volume Adjustment
•This device supports frequencies of 88-108 MHz. Press
and hold the button and then press or to adjust
the FM frequency.
•Adjust the volume with the and buttons.

6
Using Bluetooth
•Plug the device into one of the 12V charging sockets (the
device will power on after you plug it in).
•Check your smartphone to make sure Bluetooth is turned
on, then search for/select your FM transmitter. It will
show up as “CAD-6057.”
•Tune the car’s FM radio frequency to an unused FM
station.
•Tune the FM transmitter to the same frequency.
•You will now be able to stream content from your device
to your car speakers.
NOTES：
When powered on, the device will automatically connect
to the most recently used device. To avoid this, turn
Bluetooth off on the devices you aren’t streaming music
from.
The FM transmitter signal can be affected by other radio
stations or similar frequencies. This is normal, but if the
problem persists, try streaming through another FM
frequency.
Making & Answering Calls
The transmitter can make or answer a call after it is
successfully connected to your phone via Bluetooth.
•Redial the last number: double-click the button
•Reject a call: press and hold down for about 3
seconds
•Answer a call: press once
•Hang up a call: press once
Activating Siri/Google
•Double press the Forward button to activate the voice

7
command system
•Make requests like “Call mom” or “Call Dad”
Replacing the Fuse
•If your device is not charging properly, it is possible that
the fuse needs to be replaced.
•To replace the fuse, grip the charging tip (labeled in the
diagram as “the positive power supply”) and twist left. It
will unscrew.
•Replace the fuse with the extra included in the package,
then screw the device closed.

8
SUMMIT CE GROUP ONE YEAR LIMITED WARRANTY
SUMMIT CE GROUP LIMITED WARRANTY (“Warranty”) ― For Product
Categories Listed in Chart Below (as applicable, “Product”) Before
returning your Product for service under this Warranty, please (i) read
the instruction manual carefully. If you are still having trouble with
your Product, please contact Technical Support at
[e-mail]
Warning: Some Products may contain components that are small
enough to be swallowed. Please keep out of reach of children.
Subject to the terms and conditions herein, SUMMIT CE GROUP LLC
(hereinafter called “SUMMIT CE GROUP”) warrants to the original
purchaser of the Product (“Customer”) that for the applicable
Warranty Period listed below, the Product will be free from defects in
material or workmanship under normal, non-commercial use
(“Defects”). Warranty Period encompasses, as listed below, separate
“Coverage Periods” for Parts and Labor, each Coverage Period for one
year, to begin from the original date of Customer purchase. If
Customer returns a defective Product (or any component thereof)
during the applicable Warranty Period, SUMMIT CE GROUP will, at its
option, during the specified Coverage Periods for Parts and Labor (as
applicable) either: (i) repair the Product (or, as applicable, any
component thereof) or (ii) replace the Product (or, as applicable, any
component thereof) with a new or refurbished Product (or, as
applicable, any component thereof), in either case free of charge to
Customer for Parts and/or Labor (as applicable) during the specified

9
Coverage Period only, and excluding applicable shipping charges
(noted below), for which the Customer is responsible. The foregoing
states the Customer’s exclusive remedy and SUMMIT CE GROUP’s
sole liability for breach of the limited warranty contained herein.
This warranty specifically excludes any Product (or, as applicable, any
component thereof) that has been subject to or Defects resulting
from: (a) any neglect or misuse by a Customer, an accident, improper
application, violation of operating instructions for the Product, any
other Customer-induced damage, or the alteration or removal of any
Product serial number; (b) any modification of repair to Product (or,
as applicable, any component thereof) by any party other than
SUMMIT CE GROUP or a party authorized in writing by SUMMIT CE
GROUP; (c) any damage to Product (or, as applicable, any component
thereof) due to power surges, incorrect electrical
voltage, misconnection to any device, or malfunction of any device
used with the Product (or, as applicable, any component thereof); (d)
cosmetic damage to the Product (or, as applicable, any component
thereof) caused by normal wear and tear; (e) shipping damage that
occurs while the Product is in transit; (f) damage caused by heat
sources, sunlight, electromagnetic conditions, or other climatic
conditions; or (g) any acts of God. Product is sold to Customer for
personal, non-commercial use only. Product is not warranted for
Customer’s commercial or rental use.
In addition, Product is not warranted against failure, and should not
be used by Customer for any application where (i) there is a risk that
any data stored on Product will be breached or otherwise

10
compromised, or (ii) the data stored on Product is relied upon for
medical or lifesaving applications. SUMMIT CE GROUP disclaims any
Warranty for any of the foregoing uses to the fullest extent permitted
by law. Customer assumes any and all risks associated with such uses
of Product, and agrees to indemnify SUMMIT CE GROUP for any
damages claimed against SUMMIT CE GROUP for such uses. EXCEPT
FOR EXPRESS WARRANTIES STATED ABOVE AND TO THE MAXIMUM
EXTENT PERMITTED BY LAW, THE PRODUCTS ARE PROVIDED “AS IS”,
AND SUMMIT CE GROUP DISCLAIMS ALL OTHER WARRANTIES,
INCLUDING WITHOUT LIMITATION ANY IMPLIED WARRANTY (I) OF
MERCHANTABILITY, (II) OF FITNESS FOR A PARTICULAR PURPOSE, OR
(III) OF NON-INFRINGEMENT OF THIRD PARTY RIGHTS. TO THE
MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, IN NO EVENT
WILL SUMMIT CE GROUP BE LIABLE TO CUSTOMER OR ANY THIRD
PARTY FOR ANY INDIRECT, SPECIAL, INCIDENTAL, CONSEQUENTIAL,
EXEMPLARY OR PUNITIVE DAMAGES, INCLUDING, WITHOUT
LIMITATION, ANY LOST PROFITS OR REVENUES, LOSS OR INACCURACY
OF ANY DATA OR COST OF SUBSTITUTE GOODS, REGARDLESS OF THE
THEORY OF LIABILITY (INCLUDING NEGLIGENCE) AND EVEN IF
SUMMIT CE GROUP HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH
DAMAGES, SUMMIT CE GROUP’S AGGREGATE LIABILITY TO
CUSTOMER FOR ACTUAL DIRECT DAMAGES FOR ANY CAUSE
WHATSOEVER SHALL BE LIMITED TO THE CUMULATIVE PRODUCT
FEES PAID BY THAT CUSTOMER FOR THE PRODUCT CAUSING THE
DAMAGES, IF ANY. This Warranty gives Customer specific rights, and
Customer may also have other rights that vary from jurisdiction to
jurisdiction. To obtain Warranty service, Customer must email