CardioQuip MCH-10ARH User manual

MCH-10ARH
Airflow Redirection HoodTM Installation Guide
TM
Make sure the Refrigeration Module is unplugged and the
green power switch is in the OFF position before installing
the Airflow Redirection Hood.
Tools required:
PH2
With the Refrigeration Module powered off, use a #2
Phillips screwdriver to remove the four (4) side panel
screws from the Refrigeration Module cover (two per
side).
1.1
PH2
PH2
Slide the Airflow Hood down into place on top of the
Refrigeration Module. The laser-etched model number/
serial number/manufacture date should be placed at the
front of the refrigeration module next to the hinged lid.
Position the Airflow Redirection Hood so that the holes
align with the Refrigeration Module threads.
2.1
MCH-10ARH
15000000
2021-10-31
SN
LBL-47Ver. 0
©#2021, CardioQuip, LLC

MCH-10ARH
Airflow Redirection HoodTM Installation Guide
TM
Replace the four side panel screws, ensuring that they
thread straight in. The screwdriver will be at a slight angle,
so care must be taken to ensure that the screws do not
cross-thread. Tighten the screws securely.
3.1
PH2
TM
MCH-1000(i)
RUN
MCH-1000(i)
WATER TEMP
AT TEMP
SET POINT:
PUMP SPEED:
34.0
34.0
PRESETS
Standby Prime
Main
Cold
System
Test Settings
OFF
CPG:
When properly installed, the MCH-10ARH redirects
exhaust air downward from MCH-10RMS
Refrigeration Module.
for additional questions, contact CardioQuip Support at 888-267-6700
LBL-47 Ver. 0
©#2021, CardioQuip, LLC