2
www.CarnivalKingSupplies.com .||||| info@carnivalking.com
COTTON CANDY MACHINE MANUAL
General Safety Precautions
1. This manual will outline safety warnings and precautions, operating, maintenance and cleaning. The warnings and
instructions reviewed in this manual cannot cover all possible conditions and situations that may occur. Factors
such as caution and common sense cannot be built into this product and it is trusted the operator will follow these
measures.
2. This machine must never be modified and should only be used for its intended purpose.
3. Always check that the cotton candy machine is plugged into a grounded outlet with the appropriate electrical
supply. Ensure that the wall outlet being used is properly grounded. If it is not, you must install a grounded outlet.
Have the work performed only by a certified electrician who is properly qualified to meet local safety and electrical
codes.
4. Before disconnecting from the power source, be sure that all switches have been turned OFF. To unplug the
machine, firmly grasp the plug and remove from the outlet – never pull on the cord itself.
5. Ensure that the power outlet, plug and cord being used are in good, working condition. Damaged components
should be repaired by a certified electrician who is qualified to meet local safety and electrical codes. Even with a
properly functioning power cord, keep water away from the cord and avoid letting your power cord run over carpets
or heating devices.
6. If missing or broken components are found, leave the machine TURNED OFF. Do not attempt to use it. Contact a
qualified service technician to make all repairs.
7. No one under 18 should operate this machine unsupervised.
8. Keep hands, foreign objects, and loose clothing away from the spinning head while in use.
9. Always use the machine in a clean and dry area.
Operating Instructions
1. Install the bowl on top of the base using the 4 clamps located on the sides of the base. Make sure the bowl is not
in contact with the heating head. Place floss bubble shield (optional) on top of the bowl.
2. Connect the power cord to the base and plug it into a grounded outlet.
3. Switch both the “power” and “heat” switches to the ON position. Both switches will light up when turned on.
4. Allow the machine 2-3 minutes to heat prior to use.
5. Add floss sugar directly into the well in the heating head using the floss scoop. Do not overfill.
6. Cotton candy will begin to spin around the bowl as the heater head continues to operate. As the cotton candy
accumulates, it will build up and come out through the top of the spinner head. You will need to collect the cotton
candy as it comes out of the top of the unit.
7. Allow the machine to cool down for 15-20 minutes after an hour of continuous use.
Cotton Candy Machine SpecsCotton Candy Machine Specs
Item# 382CCM28
Base Dimensions 12.5” x 12.5” x 12.5”
Bowl Dimensions 28” Diameter
Voltage 110V
Wattage
Yield 2 Cones/Minute
Item# 382CCME21
Base Dimensions 12.5” x 12.5” x 12.5”
Bowl Dimensions 21” Diameter
Voltage 110V
Wattage
Yield 2 Cones/Minute
Intertek Intertek
1080W
1080W
