carole Ripplefold Drapery Panels User manual

Installation Instructions: Ripplefold™Drapery Panels
Before You Begin
Please take the time to review this guide. It will give you a few suggestions that
will make installingyour Ripplefold draperypanels a simple process. Keep this
guide with the product for future reference.
Attach the enclosed carrier pendants to each draperypanel by snapping them
into place as shown in the illustrations below. The panels will be labeled left or
right and will be configured as follows:
A. Three empty snaps attach to master carriers on leading edge
B. Carrier pendants installed on snaps
C. Single empty snap for end cap. Please note that for returns greater than
4" there will be an extra unused snap on this end of the drapery panel.
D. Draperyhook for return back to wall
Back of Left Panel
Back of Right Panel
carolefabrics.com
800-241-0920
Carrier Pendants
Before and After Installation
onto Drapery Panel Snaps
A B C D
A
B
CD

Step 1: Attach to Master Carriers
Begin by snapping the first two buttons on the leading edge to the master carrier.
Butt Master Carriers
This carrier style is used for most draperies. The snap setup is the same for baton draw and motorized draperies.
Snap the third snap into the snap on the side of the butt master carrier.
3 2 1
Left Panel
Overlap Master Carriers
This carrier style is used when overlapping drapery in the center is desired. For baton draw panels, snap the third
drapery snap into the plastic hole on the side of the master carrier. For motorized panels, snap the third drapery snap
into the first carrier.
3 2 1
Left Panel - Baton Draw
3 2 1
Left Panel - Motorized
carolefabrics.com
800-241-0920

Step 2: Attach Pendants to Carriers
Insert the remaining pre-snapped pendants into the carriers.You should hear them
click into place.
Pendant Clicked into Carrier
Step 3: Snap to End Cap
Install the last snap onto the stationary carrier in the
end cap. Remember, if the draperyreturn is greater
than 4" there will be an unused extra snap at this end
of the drapery panel.
Unused Extra Snap for Returns Greater Than 4"
Step 4: Connect Drapery Return to Wall
To create a return, ax the screw eye hook to the wall
and attach the pre-installed draperyhook to the screw
eye hook. This will return the draperypanel to the wall,
minimizing anysidelight view. The drapery pin can be
adjusted to the desired return height.
carolefabrics.com
800-241-0920

Thank you!
Thank you for purchasing this Ripplefold Drapery!We hopeyou loveyour new product as much as we loved making it for you.
Pendant Sets
Face Each Other
carolefabrics.com
800-241-0920
Step 5: Dressing the Folds
Once all of the pendants are installed, dress the
fabric into S-folds by alternating pushing the fabric
toward the wall and pulling it out toward the room.
For each drapery panel, start from the main carrier
by pushing the fabric toward the wall and work
toward the other end. Each set of two pendants
should face each other, and each “S” should take
up about 4".
Step 6: Attach Wand(s) for Baton Draw
For baton draw draperies, attach the wand to the master carrier. Simply fit the wand’s metal hook through the slot
below the snaps on the carrier.
Butt Master Carriers Overlap Master Carriers
Incorrect
Overlap Master Carrier - Motorized
Overlap Master Carrier - Baton Draw
Butt Master Carrier
About 4"
Depth