Caroma CARE 800 EASY HEIGHT ARMREST User manual

Hinge Block Installation
Fig. 2
CARE 800 EASY HEIGHT ARMREST
PLUMBERS INSTALLATION INSTRUCTIONS
PLEASE READ CAREFULLY BEFORE INSTALLATION
1. Unpack and check all components as shown in Fig. 1 above are supplied and unmarked. Fit
uniconnector into drainline if required before installing hingle block assembly (refer to pan
installation instructions.)
2. Install hinge block flush with wall. Attach with 4 x fixing screws (not supplied) in positions shown
above in Fig. 2. Use M8 dynabolts for masonry, or M8 coach screws for timber flooring.
IMPORTANT: Slide Care 800 pan over bracket and check hole alignment between pan and
bracket before tightening bracket fixing screws
Page 1 of 3
Components Overview
Fig. 1
Hingle block assy
390 45
156
Outer bush
Inner bush
Locking tabs
Right hand arm assy
Locking tab
screws
Left hand arm assy
170
Blanking Cap
COMPONENT QUANTITY
LH arm assy 1
RH arm assy 1
Hingle block assy 1
Outer bush 2
Inner bush 2
Lock tab 2
Lock screws 4
Blanking Caps 2

D82 Pan Fixing Bracket Assembly
Fig. 3
Care 800 Pan Installation
Fig. 4
CARE 800 EASY HEIGHT ARMREST
PLUMBERS INSTALLATION INSTRUCTIONS
PLEASE READ CAREFULLY BEFORE INSTALLATION
3. Attach the two (2) D82 pan fixing brackets using supplied screws though the holes in the hinge
bracket as shown above in Fig. 3. Ensure holes in pan line up with fixing brackets.
4. Install Care 800 pan as specified in pan instructions. Ensure pan is centered over hingeblock.
Ensure a full bead of silicone is used on both the foot and rear face. A strong bond is critical so
ensure floor is clean and in good condition. Allow 24hrs for sealant to set before use
Page 2 of 3
Pan and hinge
bracket alignment
D82 Fixing Bracket
Full Silicone
Bead
Cap
Fixing
head
Pan foot
Silicone
bedding
Threadedstud
Concealed
fixing bracket

Arm Installation
Fig. 5
Blanking Cap Installation
Fig. 6
CARE 800 EASY HEIGHT ARMREST
PLUMBERS INSTALLATION INSTRUCTIONS
PLEASE READ CAREFULLY BEFORE INSTALLATION
5. Rotate lock tabs upwards so tab clears slot. Install inner and outer bushes ensuring outer bush
key is aligned to arm key as shown above in Fig. 5. Install arms by tilting back and aligning key
into slot. Ensure they rotate up and down and locking mechanism functions. Arms should lock in
upper and lower position, button releases lock. Now rotate lock tab down into closed position.
6. Install blanking caps into pan, ensure cap is flush with outside of pan and there are no visible
gaps (silicone may be used to secure cap to pan). Ensure caps do not interfere with arm movement.
Page 3 of 3
Rotate arm
Rotate upwards
so tab clears slot
Lock tab
Lock screws
Slot
Date of Issue: 13.09.2013
Issue No: 2
Blanking cap
Arm Key
Outer bush
key
Inner bush
Blanking cap
Pan
Arm