Carrier CAVIUS 4002-008 User manual

Carbon monoxide alarm device
Commercial reference : 4002-008
Developed by CAVIUS
This Cavius carbon monoxide (CO) alarm is de-
signed and tested to detect CO in private homes,
camping trailers, mobile homes and caravans. It will
provide early warning of the presence of CO.
PLEASE READ THE USER GUIDE
CAREFULLY BEFORE INSTALLATION AND
RETAIN FOR FUTURE USE.
SAFETY INSTRUCTIONS:
The device comes with a 3V lithium battery. Batteries
are to be handled with care and battery powered de-
vices should be kept out of reach of children. Do not
try to recharge or burn the batteries.
INFORMATION ABOUT CARBON MONOXIDE:
CO - Carbon monoxide - is known as the “silent killer”
because it is odourless, tasteless and colourless.
It can kill in few minutes.This apparatus may not
prevent the chronic effects of Carbon Monoxide ex-
posure.
All people are at risk for CO poisoning. Unborn ba-
bies, infants, the elderly, and people with chronic
heart disease, anemia, or respiratory problems are
generally more at risk than others. The apparatus will
not fully safeguard individuals at special risks
Breathing CO can cause headache, dizziness, vom-
iting, and nausea. If CO levels are high enough, you
may become unconscious or die.
1. TECHNICAL INFORMATION:
Diameter: 40mm Height: 38m.
Type of alarm: Type B apparatus with elec-
tro-chemical CO sensor.
Battery: Powered by a non-replaceable 3V CR123
Lithium battery with 10-year life (included).
IMPORTANT: Do not try to replace the bat-
tery. Replace the product if the battery fails.
Product Life: 10 years after manufacturing date.
Complies to standards: EN50291-1:2018,
EN50270, EN50271, EN60335, RoHs, REACH.
Working condition: -10 to +400C, 30 to 95% non-con-
densing.
Storage/Transport: -20 to +500C, 10 to 95% non-
condensing.
Alarm Sound Level: The minimum sound level is 85
dB at 3 meters.
2. THE BEST AREAS TO INSTALL YOUR COALARM:
• Ideally, an apparatus should be installed in every
room containing a fuel-burning appliance.
• Near bedrooms and living areas.
• On each level of your home.
• 1 to 3 meter away from all fuel burning appliances.
• At eye level to allow optimum monitoring of the
in dicator lights.
• Install as High as possible as CO rises when mixed
with heat.
• You can t on a wall but as high as possible.
3. AREAS WHERE NOT TO INSTALL CO ALARMS:
• In an enclosed space (for example in a cupboard or
behind a curtain).
• Where it can be obstructed (for example by
furniture).
• Directly above a sink.
• Next to a door or window.
• Next to an extractor fan.
• Next to an air vent or other similar ventilation
openings.
• In an area where the temperature may drop below -10
°C or exceed 40 °C.
• Where dirt and dust may block the sensor.
• In a damp or humid location.
• In the immediate vicinity of a cooking appliance.
4. PLACEMENT:
The CO alarm is designed to be installed on the wall
or a ceiling.
UK
INSTALLATION GUIDE
Sounder
Yellow LED
Fault indicator
Green LED
Power indicator
Test/ hush
button
Mounting
base
Red LED
Alarm indicator
Siting of CO alarms
CO
Minimum 15cm from ceiling
Wall
Ceiling
Minimum 1,20m to 1,50m from the oor
Floor

5. INSTALLING YOUR CO ALARM:
CAUTION: This alarm should be installed by a
competent person.
The installation of this device should not be
used as a substitute for proper installation, use
and maintenance of fuel burning appliances,
including appropriate ventilation and exhaust
systems.
It does not replace a smoke alarm.
Installation with screw and plug:
Detach the alarm from the mounting base by twisting
counter clockwise.
Use the mounting base to mark up horizontally the
screw holes on the wall.
Attach the alarm by twisting clockwise.
Please note: The label in the product must not be
removed as it contains important information regard-
ing the product.
6. TEST FUNCTION:
After installation and at least once per quarter, test
your alarm to make sure it is operating correctly.
It is recommended to check visually every week if the
green LED ashes correctly (every minute)
When the top button is pressed the alarm sounder
will sound, and when the button is released, the
alarm will make a self-test of the sensor and battery
for approximately 9 seconds. During this delay the
three LEDs will be ashed in sequence. The result
of the test will be indicated after the test has been
completed.
If the test passes, the green LED will emit for 3 sec.
If the test fails, a fault indication will be given (See
section 11).
After the test function is performed, the alarm will
need to recover for one minute before the next test
can be done (to allow the sensor chamber to re-set-
tle after the test current is applied).
The alarm will also do a self-test every 24 hour and
test the sensor for faulty sensor, drift or short circuit.
TIP: It is safe to cover the sound output hole with
your nger during the testing to minimize the sound
level emitted.
7. OTHER INFORMATION:
Do not paint the alarm.
Disposal: Please dispose the product properly at the
end of life. This is electronic waste which should be
handled properly.
WARNING: Batteries shall not be exposed to exces-
sive heat such as shine, re, or the like. Note the
local country regulations regarding installation.
WARNING: To prevent injury, this apparatus must be
permanently xed to the ceiling/wall in accordance
with the installation instructions.
The CE mark affixed to this product confirms its
compliance with the European Directives which
apply to the product.
All Rights reserved: CAVIUS Aps assumes no re-
sponsibility for any errors, which may appear in this
manual. Furthermore, CAVIUS Aps reserves the
right to alter the hardware, software, and/or speci-
cations detailed herein at any time without notice,
and CAVIUS Aps does not make any commitment
to update the information contained herein. All the
trademarks listed herein are owned by their respec-
tive owners. Copyright © CAVIUS Aps.
Developed by CAVIUS Aps Julsøvej 16, DK-8600
Manufactured in P.R.C.
Contact: CAVIUS Ltd, Edinburgh, Scotland, EH3 9DQ
Tel: [phone], www.cavius.com
EN50291-1:2018
EN50291-2:2010
www.cavius.com
400148 rev3
Mark up screw holes with a pen
Use the enclosed screws
and plugs for installation
Peak ceiling
Minimum 30cm
from peak
Minimum 30cm
from wall
Wall
Ceiling
1 to 3m from replace
Wall