Carson MeasureLoupe CP-45 User manual

©
MEASURELOUPE
TM
11.5x LED/UV LIGHTED LOUPE
INSTRUCTIONS FOR USE
CP-45
Support
Stand
LED/UV
Power Switch
Removable
Reticle

/B*�g
Installing the Battery
1. Turn cap at end of handle counter-
clockwise and remove.
2. Remove battery housing from handle. Load three AAA batteries into
housing following polarity markings. Insert loaded battery housing
positive end first into handle and replace cap.

Directions for Use:
IMPORTANT: For best results, place base of magnifier directly upon viewing surface.
To illuminate your viewing subject,
activate LED or UV light using switch
located on side of handle.
For hands free use, make sure support
adapter is attached to the end of the
handle so that loupe base will be flush
to viewing surface.
This item comes with a reticle marked in
both inches and millimeters. To remove
reticle, turn counterclockwise to unlock
and lift up to remove.
To attach reticle, line up slits in reticle
with notches inside base of loupe.
Press reticle into place and turn
clockwise to lock.
types within brands. Different attributes
may cause the battery to leak fluid,
overheat or explode. Do not expose to fire
or excessive heat. Inspect all batteries for
signs of corrosion or leakage. Use alkaline
batteries only, rechargeable batteries not
recommended. Insert all batteries in the
direction indicated.
CLEANING
Clean using microfiber lens cloth. Do not
use any abrasives, chemical cleaners or
solvent.
WARNING
Do not look directly into the LED's and do
not shine them into the eyes of others. As
with other high intensity light sources, eye
damage may occur. Do not look through
the lens directly at the sun or other bright
lights, as eye damage may occur.
WARNING: Do not mix old and
new batteries, batteries with
different brand names or different
FIRE HAZARD: KEEP MAGNIFIER
AWAY FROM DIRECT SUNLIGHT TO
PREVENT ACCIDENTAL FIRE.
&
CP-45 / ©2017-R2