10
Tilt angle
Normal display mode
Go ahead and press the Set button repeatedly to see the different
setting modes. You will see the following in sequence:
12 01 00 <incrementing number> 45
When you have finished the cycle, the display will be blank again.
To begin setting the time, press the Set button once. The display will
show 12. Pressing the Adv button causes this number to alternate
between 12 and 24. When 24 is selected, the watch is in 24 hour
display mode and the hours will range from 00 to 23. When 12 is
selected (the default), then the watch is in 12 hour mode and the
hours will range from 01 to 12.
Press Set to enter hour setting mode. The watch displays a blinking
01. This is the hours. To increment the hours, press the Adv button
repeatedly until the proper hour is displayed.
Press Set to set the tens of minutes. The watch displays the current
minutes with the left digit blinking. Press Adv repeatedly to set the
left digit of the minutes properly.
Press Set to set the units of minutes. The watch displays the current
minutes with the right digit blinking. Press Adv repeatedly to set the
right digit of the minutes properly. It’s a good idea to set it one
minute ahead so that the seconds reset that follows will leave the
watch set to the correct minute.
Press Set to enter the seconds reset mode. If you like, you may reset
the seconds to 00 when your reference clock reaches the top of the
minute. However, the setting mode automatically turns itself off after
20 seconds have elapsed without any button pushes, so press Adv
every few seconds to stay in timesetting mode.
