CBS ArcSafe RSA-102 Owner's manual

*
CBSArcSafe®
R
S
A
-
102
Installation and Operation
P.O. Box 550
Argyle, TX 76226
( 40) 382-4411
www.cbsarcsafe.com
FP 400 Amp
Switchmatic

RSA-102 Technical Manual 2
© 2011 CBS ArcSafe® 2012-01-23
1.0 Installation
DANGER!
*Ensure that the switch to be serviced matches the switch discussed. If the breaker to be
serviced does not match, please call CBS ArcSafe® for more information re ardin switchin
applications for your particular model of switch.
1.1 RSA-102 Alignment Locations for Breaker Installation
ATTENTION
The
numbers
depicted on the breaker below correspond to where t
he
RSA-102 needs to ali n on the breaker.
1
2
3
4
5
Figure 1: FP 400 Amp Switchmatic.

RSA-102 Technical Manual 3
© 2011 CBS ArcSafe® 2012-01-23
The locations in Fi ure 2 need to ali n with the numbered locations in Fi ure 1, sli ht
adjustments need to be made for proper operation. These adjustments will be discussed in
the next section of the manual.
ATTENTION
The
numbers
depicted on the
RSA
-
102 correspond to the breaker
ali nment locations from Fi ure 1.
1
2
4
3
5
Figure 2:
RSA
-
102 Ali nment locations.

RSA-102 Technical Manual 4
© 2011 CBS ArcSafe® 2012-01-23
1.2 RSA-102 Adjustment Locations
To widen the RSA-102, loosen the screws of the followin locations and
slide the left support outward. This adjustment will help the RSA-102
fit more securely between the breaker door and the left hin e, as seen
in the ima e below.

RSA-102 Technical Manual 5
© 2011 CBS ArcSafe® 2012-01-23
Adjustments will need to be made to the two motor stops above to
limit the travel of the handle. This will keep the RSA-102 to from
dama in the ON/OFF Switch. They can be adjusted with an Allen
wrench then raised or lowered to the proper hei ht.
The two handle rips can be adjusted to fit a wider handle by
unscrewin and movin to the open holes, as seen in the ima e above.

RSA-102 Technical Manual 6
© 2011 CBS ArcSafe® 2012-01-23
2.0 Opening Closing the Switch
1. Ensure that the unit is properly installed on the switch.
2. Connect the cable from the RSO to the motor control box.
3. Power the RSO I on.
ATTENTION
Please ensure that either the batteries on the unit are fully charged or the
unit is plugged into AC power.
4. If the switch is connected (on) press and hold the “TRIP” button until the switch opens to turn
the switch off.
5. If the switch is disconnected (off) press and hold the “CLOSE” button until the switch closes to
turn the switch on.

DANGER!
*Ensure that personnel usin this equipment are adequately trained in the operation
of the switch ear they are plannin to work with; that they are correctly stationed
outside the arc flash boundary; and that they comply with all applicable Federal,
State, Local, and In-house safety re ulations and procedures. Attention should be
iven to distance, an le, and personal protective equipment (PPE).
P.O. Box 550
Argyle, TX 76226
Tel: [phone]
Fax: [phone]
Website: www.CBSArcSafe.com
Email: [email protected]