Extension numbers in default are from 601 to 608 and can be changed to 1 digit, 2 digits, 3 digits or 4 digits numbering as
explained under the heading “Flexible Numbering”.
The Flash time of the PBX can be changed as described below:
Dial #0000 + Dial 00 L #
Here, L= 1 (for 0.8 secs)
2
(for 1.0 secs)
3
(for 1.2 secs)
4
(for 1.5 secs)
5
(for 1.8 secs)
Default: 0.4 Secs
Extension numbers can be changed to a desired number of 1 digit, 2 digit, 3 digit or 4 digits from 11 –6999.
The numbering can either be 1 digit, 2digit, 3 digits or 4 digits in any combination.
The flexible number cannot begin with digits 0, 7, 8 and 9.
Procedure:
Dial #0000 + 9000 + # (This also resets all the flexible numbering of the PBX)
Dial #0000 + 9 N ABCD #
Where, N = Last digit of the original extension number (This original number always remains the one
that is printed on the MDF even if flexible numbering is done).
ABCD = The new Extension number. For less than 4 digits, dial # at the end Of Extension Number.
If all the new numbers to be made in sequence then following programming can be done with single program. This avoids
lengthy programming:
Dial #0000 + 9000 L K #
Where, L = Length of new numbers –3 digits or 4 digits
K = First digit of the new numbering. If K=2 then the numbering will become 201 (or 2001)
Onwards. Then all those Numbers can be changed through the following programming.
Default: 601,602, to 608
Some or all extensions can be programmed to get Junction Line on lifting the Handset.
To dial internal numbers, dial on lifting the Handset. You will get internal dial tone of the PBX.
To program an extension to get a free Junction line on lifting handset,
Dial #0000 + 20 N#
Where, N= last digit of Extension numbers that is to be programmed for Direct Junction Access.
Dial #0000 + 20 # - To convert all Extensions in “Hot Line to Junction” mode
Dial #0000 + 21 N # - To convert NN Extension in normal mode.
Dial #0000 + 21 # - To convert all Extensions in normal mode.
Note: When all Extensions are converted to Hot Line then to get into the Programming mode, lift Handset –dial # 0000
+ Whatever Programming to be done.
Default: Normal Mode
Some or all extensions can be programmed to get connected to an Extension, on lifting the Handset.
To dial internal numbers, dial on lifting the Handset. You will get internal dial tone of the PBX.
To program an extension in this mode,
Dial #0000 + 883 N XXXX#
Where, N= last digit of Original Extension numbers that is to be programmed for this feature.
XXXX = Extension number to which call will land in Hotline feature..
Dial #0000 + 884 N # - To convert N Extension in normal mode.
Note: When all Extensions are converted to Hot Line then to get into the Programming mode, lift Handset –dial # 0000
+ whatever Programming to be done.
Default: All extension is in Normal Mode.
When the system is switched OFF, the Junction lines get directly connected to following respective extensions.
Junction Number Extension Number to which it gets connected
01 601
