CDA he6050ss Reference manual

Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY
T : 01949 862 012 F : 01949 862 003 E : customer[email protected] W : www.cda.eu
he6050ss electric hob
Manual for Installation, Use and Maintenance

2
Contents:
3 Important
5 Important Notes
6 Using Your Hob
8 Ecient Use Of Your Hob
9 Care And Maintenance
11 Fitting The Hob
12 How To Install The Hob
14 Mains Electricity Connection

3
Important
The CDA Group Ltd cannot be held responsible for injuries or losses
caused by incorrect use or installation of this product. Please note that
CDA reserve the right to invalidate the guarantee supplied with this
product following incorrect installation or misuse of the appliance or
use in a commercial environment.
This appliance is not designed to be used by people (including
children) with reduced physical, sensorial or mental capacity, or
who lack experience or knowledge about it, unless they have had
supervision or instructions on how to use the appliance by someone
who is responsible for their safety.
Under no circumstances should any external covers be removed for
servicing or maintenance except by suitably qualified personnel.
Appliance information:
Please enter the details on the appliance rating plate to assist CDA
Customer Care in the event of a fault with your appliance and to
register your appliance for guarantee purposes.
Appliance Model
Serial Number

4
CE Declarations of Conformity:
This appliance has been manufactured to the strictest standards and
complies with all applicable legislation, including Electrical safety (LVD)
and Electromagnetic interference compatibility (EMC). Parts intended
to come into contact with food conform to EEC/89/109.
IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE
PRODUCT IN ACCORDANCE WITH EC DIRECTIVE 2002/96/EC.
At the end of its working life, the product must be taken to a special
local authority waste collection centre or to a dealer providing
appliance recycling services.
Disposing of a household appliance separately avoids possible
negative consequences for the environment and health. It also
enables the constituent materials to be recovered, saving both energy
and resources. As a reminder of the need to dispose of household
appliances separately, the product is marked with a crossed-out
wheeled dustbin.

5
Important Notes
• Please note:
•Electric hobs become hot and remain hot during and immediately after
use. Do not touch the hob until it has been allowed to cool.
•Keep children away from the appliance when in use.
•Never use the hob top for storage.
•Pan handles should never stand out beyond the edge of the worktop.
This will ensure children cannot reach them.
•Do not switch on the hotplates without cookware in place.
•Do not lean over the hob when it is in use.
•Follow the cleaning instructions carefully.
•Ensure the base of the saucepan is clean and dry before placing it on
the hob.
•After use, please ensure that the control knobs are in the ‘O”
position.
•This hob (Class 3) has been designed for use only as a cooking
appliance. Any other use (e.g. heating rooms) should be considered
incorrect and therefore dangerous.
•The appliance is not intended to be operated by any means of an
external timer or separate remote-control system.

6
Using Your Hob
HOTPLATE SWITCHES:
The power of each hotplate can be varied using the control knob to
select the required heat.
The table below shows the heat at each of the 6 settings:
5
6
7
8
9
Heat setting Description
1 Very gentle
2 Gentle
3 Slow
4 Medium
5 High
6 Very high
Fig.1
1
2 3
4
Electric hotplates:
1. 180mm (FL) 1.5kW
2. 145mm (BL) 1.0kW
3. 180mm (BR) 2.0kW Rapid
4. 145mm (FR) 1.5kW Rapid
Control panel:
5. (BR) 180mm Rapid hotplate control
6. (BL) 145mm hotplate control
7. (FL) 180mm hotplate control
8. (FR) 145mm Rapid hotplate control
9. Hob in use indicator light

7
The ‘OFF’ position is indicated by the symbol ‘O’.
The indicator will light when the hotplate is in use.
When you have finished cooking, check to ensure that the hotplates
are o and the indicator is not lit.
Before using your hob for the rst time, switch the hotplates on
for a FEW SECONDS to burn o any grease left over from the
manufacturing process.

8
Ecient Use Of Your Hob
The hob is equipped with hotplates of dierent sizes, designed to
accommodate most shapes and sizes of pan. For best results, only
use pans with flat bottoms and choose an appropriate hotplate
depending on the size of the pan. The most ecient use of the hob is
shown below, where the pan and hotplate are correctly chosen.
Use pan lids where possible to minimize the energy usage of your
appliance.
Turn o each hotplate a few minutes before the end of cooking time.
The residual heat in the hotplate will continue to cook the food for the
remaining cooking time. This will also help preserve the look of your
appliance.
The table below shows the sizes of pan that should be used with each
hotplate:
Hotplate Size
145mm
180mm
Maximum Pan Size (cm)
16
20
Minimum Pan Size (cm)
12
16
Fig.2

9
Care and Maintenance
The hob has a stainless steel surface, you should use a non-abrasive
cleaner. Any abrasive cleaner (including Cif) will scratch the surface and
could erase the control panel markings. Stainless steel can be eectively
cleaned by simply using a dilute solution of water and washing up liquid
and drying to a shine with a clean cloth.
Over time with use, the stainless steel surface may discolour; this is
normal and does not constitute a fault with this appliance. Proprietary
stainless steel cleaners are available.
IMPORTANT:
Steam cleaners must not be used when cleaning these appliances.
HOTPLATE CARE:
The finish of the cast iron hotplates is designed to be durable in use. The
following tips should be observed to get the best from your hob:
1. Do not use decorative covers; these can cause damage to the surface
and lead to rust.
2. Use a special hotplate surface cleaner to protect and restore the
surface of the hotplates.
3. Do not use soap and water on the hotplates. Wipe up spills and
splashes immediately.
4. Never operate the hob without a pan, unless it is for a few seconds (as
below).
5. Deposits of fat can be burned o by turning the hotplate on for a few
seconds. The fat will brush o when the appliance has cooled down.

10
IF YOUR HOB IS NOT WORKING:
1. Check that the mains supply has not been switched o.
2. Check that the fuse or circuit breaker has not blown/tripped.

11
Fitting The Hob
Unpacking the hob:
•Take care not to lose or mishandle any parts.
Fitting position of the hob:
This appliance must be installed a minimum of 50mm from any back
wall and a minimum of 150mm away from any adjacent vertical surfaces,
e.g. a tall cupboard end panel. This may be reduced to 125mm if the
adjacent surface is resistant to fire (tiles or steel, for example). These
dimensions are shown in Fig 3.
If tting a cooker hood above the hob:
If a cooker hood is to be installed above the hob, the height of the hood
above the hob must be at least 600mm (650mm is recommended) (Fig
4). If the instructions supplied with the hood dictate that the hood must
be installed at a height greater than 600mm, then that height is the
minimum required.
Wall furniture requirements:
The minimum height of any cabinet immediately above the hob is
900mm. The minimum height of any adjacent units (including light
pelmets) is 400mm, unless they are manufactured from a material
resistant to fire (steel, for example).

12
Notes:
•Do not position this appliance above a refrigeration unit. The heat
generated may cause the unit to fail.
•This appliance is designed to be installed into cabinet units capable of
withstanding temperatures of 65°C above ambient or greater (typically
80-90°C).
•If the hob is to be installed above a working drawer, then a partition
should be fitted to protect the contents and user from the heat
generated during use. This should be fitted 100mm below the hob.
•Never place perishable foods in the cupboard below the appliance.
How To Install The Hob
How to install the hob:
Overall dimensions of the hob: Width: 580mm Depth: 500mm
Worktop cut-out dimensions: Width: 557mm Depth: 477mm
1. Make the required hole in the worktop. Note that before doing this,
check the instructions supplied with any cooker hood to ensure that
you will have the required clearance. The cut-out (Fig 3) shows a
61.5mm gap from the wall to the cut-out edge. The distance for the
hob, when fitted, to the back wall is 50mm.
2.Position the hob seal, as shown in the diagram below (Fig 5), ensuring
that the ends meet without overlapping. Do not use silicone type
sealant.
3.Secure the hob to the worktop using the fixing brackets and screws
supplied, as shown in the following diagram (Fig 6).
Remove any excess sealant after tightening the brackets.

13
Fig.3 Fig.4
Fig.5 Fig.6
185mm 185mm
>61.5mm
560cm
>165mm>165mm
557mm
477mm
>600mm
3cm 4cm

14
Mains Electricity Connection
Warning! this appliance must be earthed
We recommend that the appliance is connected by a qualified
electrician, who is a member of the N.I.C.E.I.C. and who will comply
with the I.E.T. and local regulations.
This appliance is intended to be connected to xed wiring and is
not suitable for connection to a 13A plug or 13A supply.
This appliance is intended to be connected to fixed wiring by a
double pole switch, having a contact separation of at least 3mm in
all poles. The switch must be positioned no further than 2m from the
appliance.
Please note:
•The mains cable must only be replaced by a qualified electrician
or service engineer and must be of equivalent or better rating (i.e.
2.5mm², HO5RR-F).
•This appliance is intended to be connected to the mains supply with
a cable of cross section area 2.5 mm². A larger cable will not fit the
terminal connections.
•The marking of the current rating of the fuse or circuit breaker
protecting this appliance should be marked on the socket outlet.
•Assembly and electrical connection should be carried out by
specialised personnel.

15
Hotplate Size Nominal Rating (kW)
180mm 1.5
145mm 1.0
180mm Rapid 2.0
145mm Rapid 1.5
•When installing this product we recommend you seek the help of
another individual.
TECHNICAL DATA:
The table opposite shows the rated output of each hotplate:
Mains electrical voltage: 230 - 240Vac, 50Hz
Total rated electrical input: 6.0kW

Please contact our Customer Care Department for Service on the details below
Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY
T : 01949 862 012 F : 01949 862 003 E : [email protected] W : www.cda.eu