CDN TM8 User manual
Features
• Dual function
• Memory
• Counts up & down
• Clock
• Stopwatch
• Loud and long alarm
• Stop and restart
• Lock
• Counts up after zero
• Food-safe ABS plastic
• Sliding mode switch
• International time
• 3-way mounting: pocket clip/magnet/stand
• Battery and instructions included
Note: Remove sticker from display before use.
Note: In the following instructions, names of the control
buttons are shown in CAPS. Function information that appears
on the display is shown in BOLD CAPS.
Battery Installation
Replace battery when LCD becomes dim or alarm
level declines.
1. Remove battery cover on the back by sliding it
in the direction of the arrow.
2. Install one LR44 battery, positive (+) side up.
A brief alarm sounds.
3. Replace the battery cover until it clicks shut.
Operating Instructions
A. Set Clock
1. Slide switch on the right side to CLOCK to
select clock mode. AM or PM appears on the
display in 12-hour time.
2. Press and hold the CLEAR button for 2 seconds
to switch between 12-hour, AM/PM time, and
24-hour, international time.
3. Press the HR MIN and/or SEC buttons
to enter the desired time. Press and hold for
fast advance.
B. Count Down
1. Slide switch on the right side to TIMER to
select the count down mode. TIMER appears
on the display.
2. Press the HR MIN and/or SEC buttons
to enter the desired time. Press and hold for
fast advance.
Note: The timer retains any time showing on the display
when the sliding mode switch is moved to another
position.
3. Press the MEMORY button to enter the set time
into memory. MEMORY appears on the display.
a. Press the MEMORY button to recall
the set time.
b. Press the MEMORY button, then press
the CLEAR button, to clear the set time
from memory.
4. Press the START/STOP button to start
counting down.
Note: TIMER ashes on the display during count down
when in other modes.
5. Press the START/STOP button to interrupt
the count. Press START/STOP again to resume
the count.
6. The alarm sounds and TIME’S UP ashes
on the display when the count reaches
0:0000. The timer counts up the overtime
since reaching 0:0000. The maximum overtime
is 10 hours.
7. The alarm and ashing stop automatically after
60 seconds while the count up continues.
Press START/STOP to stop the alarm and the
count up, and reset to 0:0000.
8. Press CLEAR when timer is stopped to reset
to 0:0000.
Model: TM8
Multi-Task Timer & Clock
Counts 24 hours by minutes & seconds
C. Count Up – Stopwatch
1. Slide switch on the right side to COUNT UP to
select the count up mode. COUNT UP appears
on the display.
2. Press the START/STOP button to start
counting up.
Note: COUNT UP ashes on the display during count up
when in other modes.
3. Press the START/STOP button to interrupt
the count. Press START/STOP again to resume
the count.
4. Press CLEAR when timer is stopped to reset
to 0:0000.
Note: The timer retains any time showing on the display
when the sliding mode switch is moved to another
position.
Care of Your Product
• Avoid exposing your timer to extreme
temperatures, water or severe shock.
• Avoid contact with any corrosive materials such as
perfume, alcohol or cleaning agents.
• Wipe clean with a damp cloth.
© 2006 Component Design Northwest, Inc. Made in China CD9999106en - 11/06 EHC 614 885 -2497
The information in this document has been reviewed and is
believed to be accurate. However, neither the manufacturer nor
its afliates assume any responsibility for inaccuracies, errors
or omissions that may be contained herein. In no event will
the manufacturer or its afliates be liable for direct, indirect,
special, incidental or consequential damages arisen by using
this product or resulting from any defect/omission in this
document, even if advised of the possibility of such damages.
The manufacturer and its afliates reserve the right to
make improvements or changes to this document and the
products and services described at any time, without notice
or obligation.
5-Year Limited Warranty: Any instrument that
proves to be defective in material or workmanship
within ve years of original purchase will be
repaired or replaced without charge upon receipt of
the unit prepaid at: CDN, PO Box 10947, Portland,
OR 97296-0947. This warranty does not cover
damage in shipment or failure caused by tampering,
obvious carelessness or abuse.
Other CDN Timer manuals
