CDN TM15 User manual

Features
• Counts up & down
• Extra big digit
• Loud and long alarm
• Stop and restart
• Last count recall
• Counts up after zero
• Food-safe ABS plastic
• 3-way mounting: magnet/stand/loop
• Battery and instructions included
Note: Remove sticker from display before use.
Note: In the following instructions, names of the control
buttons are shown in CAPS. Function information that appears
on the display is shown in BOLD CAPS.
Battery Installation
Replace battery when LCD becomes dim or alarm
level declines.
1. Remove battery cover on the back by sliding it
in the direction of the arrow.
2. Install one 1.5V AAA battery observing polarity
shown in compartment. A brief alarm sounds.
3. Replace the battery cover until it clicks shut.
Operating Instructions
A. Count Down
1. Press the MIN and/or SEC buttons to enter the
desired time. Press and hold for fast advance.
2. Press the START/STOP button to start
counting down. M and S ash on the display.
3. Press the START/STOP button to interrupt the
count. Press START/STOP again to resume
the count.
4. The alarm sounds and the timer counts up
when the count reaches 00:00.
5. The alarm stops automatically after 60 seconds
while the ashing and count up continues.
Press START/STOP to stop the alarm and the
count up. The last count is recalled.
6. When timer is stopped, press both MIN and
SEC buttons simultaneously to reset to 00:00.
B. Count Up
1. When timer is stopped, press both MIN and
SEC buttons simultaneously to reset to 00:00.
2. Press the START/STOP button to begin the
count up. M and S ash on the display.
3. Press the START/STOP button to interrupt the
count. Press START/STOP again to resume
the count.
4. Press both MIN and SEC buttons
simultaneously to reset to 00:00.
Care of Your Product
• Avoid exposing your timer to extreme
temperatures, water or severe shock.
• Avoid contact with any corrosive materials such as
perfume, alcohol or cleaning agents.
• Wipe clean with a damp cloth.
Model: TM15
Extra Big Digit Timer
100 minutes by seconds

© 2006 Component Design Northwest, Inc. Made in China CD9999112en - 11/06 EHC 614 885-2497
   
  
  
  
  
 
The information in this document has been reviewed and is
believed to be accurate. However, neither the manufacturer nor
its afliates assume any responsibility for inaccuracies, errors
or omissions that may be contained herein. In no event will
the manufacturer or its afliates be liable for direct, indirect,
special, incidental or consequential damages arisen by using
this product or resulting from any defect/omission in this
document, even if advised of the possibility of such damages.
The manufacturer and its afliates reserve the right to
make improvements or changes to this document and the
products and services described at any time, without notice
or obligation.
5-Year Limited Warranty: Any instrument that
proves to be defective in material or workmanship
within ve years of original purchase will be
repaired or replaced without charge upon receipt of
the unit prepaid at: CDN, PO Box 10947, Portland,
OR 97296-0947. This warranty does not cover
damage in shipment or failure caused by tampering,
obvious carelessness or abuse.