Cecilware Radiance 5A User manual

Radiance™Cappuccino Dispenser
Grindmaster Connect™Manual
Multiple national and
international patents
pending
Grindmaster-Cecilware
4003 Collins Lane, Louisville, KY 40245 USA
Phone: [phone] Toll Free: 800.695.4500
Fax: [phone]
Web: gmcw.com Email: [e-mail]
Safety Information .................................................2
Wi-Fi Connection ....................................................4
Grindmaster Connect™ Operation........................6
Customizing ............................................................7
Thank you for purchasing this quality beverage dispenser. For your safety and the safety of others, read all
warnings and the operator manual before installing or using the product. Properly instruct all operators. Keep
training records. For future reference, record serial number here:
Table of Contents
Model: Radiance 5A pictured
©2016 Grindmaster-Cecilware
Printed in USA
0816 Form # CW-322-01
Part # 390-00040
Grindmaster-Cecilware provides the
industry’s BEST warranty. Visit gmcw.com
for warranty terms and conditions.
Radiance 5A, 5BW, 5CW Radiance 10A, 10BW, 10CW

2 Cecilware®Radiance Grindmaster Connect™Manual
Lifting hazard. Single person lift could cause injury. It is required that moving or lifting the unit be done by two
people to avoid injury.
For safe and proper operation the appliance must be placed in a stable, vertical position.
Do not use this appliance without the legs in place.
To reduce risk of serious burns or scalding do not place hand or other body parts under dispenser.
To avoid pinching injury, use care when closing door.
CAUTION
To reduce risk of electrical shock, do not remove side panels. No user-serviceable parts inside. Refer servicing to
qualified personnel.
Certain internal parts are intentionally not grounded and may present a risk of electric shock only during
servicing. Service Personnel – Do not contact the following parts while the appliance is energized: power supply.
The appliance is not intended for outdoor use.
Do not clean with a pressure washer or use in an area where a pressure washer may be used.
Cleaning and maintenance shall be made only by properly trained persons with supervision.
When installing, wait for water tank to fill before opening door. Otherwise, unit can tip over and may cause
severe injury.
Do not open door while product is dispensing.
This appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
Do not alter or deform the power cord or plug in any way! Altering or deforming the plug may cause electrical
shock, damage unit and will void warranty.
WARNING
Safety Information
Important Safety Information
This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages
that follow this symbol to avoid possible injury or death.
For your safety and the safety of others, read all warnings and the operator manual before installing or using
the product.
DANGER: This term warns the user of imminent hazard that will result in serious injury or death.
WARNING: This term refers to a potential hazard or unsafe practice, which could result in serious injury or death.
CAUTION: This term refers to a potential hazard or unsafe practice, which could result in minor or moderate
injury.
NOTICE: This term refers to information that needs special attention or must be fully understood.
Observe machine voltage configuration. Do not apply improper voltage to machine or damage to machine may
occur.
For use on individual dedicated branch circuit only.
Do not use extension cord.
Do not allow a magnet near screens.
Do not clean with pressure washer.
Do not allow water to be splashed or poured on front, sides, top, or back.
NOTICE

Radiance Grindmaster Connect™Manual Cecilware®3
Wi-Fi Models only:
Contains Transmitter Module FCC ID: 2AHRD
This device is granted for use in mobile only configurations in which the antennas used for this transmitter
must be installed to provide a separation distance of at least 20 cm from all person and not be co-located
with any other transmitters except in accordance with FCC multi-transmitter product procedures.
Wi-Fi AGENCY CERTIFICATIONS
FCC ID: 2AHRD-EPN8508GS
Certificate Number: 162180419/AA/00
AGENCY STATEMENTS
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC Notice: Any changes or modifications not expressly approved by the Grindmaster-Cecilware could void
the user's authority to operate the equipment.
NOTICE
Safety Information (continued)

4 Cecilware®Radiance Grindmaster Connect™Manual
Wi-Fi Connection
USB and HDMI Ports Diagram
USB to Wi-Fi Board
(only on A, BW, and CW units)
HDMI to Wi-Fi Board
(only on BW and CW units)
View with door open
Radiance 5
Status LED’s on Main
Control Board
Reset Button on Main
Control Board
USB to Main
Control Board

Radiance Grindmaster Connect™Manual Cecilware®5
View with door open
Radiance 10
USB to Wi-Fi Board
(only on A, BW, and CW units)
HDMI to Wi-Fi Board
(only on BW and CW units)
Status LED’s on Primary
Control Board
Reset Button on Primary
Control Board
Reset Button on
Secondary Control Board
USB to Secondary Control Board
USB to Prime Control Board
Status LED’s on
Secondary Control Board
Wi-Fi Connection (continued)
USB and HDMI Ports Diagram (continued)

6 Cecilware®Radiance Grindmaster Connect™Manual
To change the Wi-Fi password:
If the unit does not have a video display, connect a
monitor to HDMI port.
1. Connect a USB mouse (either wired or wireless) to
the USB port labeled “Wi-Fi Control” on the
underside of the door. (See diagrams on previous
pages.)
2. If the Video Merchandiser is playing, right-click to
access the navigation icons at bottom of screen.
3. Select the center Home icon,
then select the Apps icon,
then select the Settings icon.
4. Ensure Wi-Fi is “ON”. If not, set switch to “ON”.
5. Select your Wi-Fi network from the list on the right
side of the screen.
6. Type the network password and select “CONNECT”.
Contact your network adminstrator if you don’t
know your network name or password.
7. To return to the Video Merchandiser, select Home
icon and navigate to the NoviSign icon:
Then select “GO”.
Wi-Fi Adjustments
Some Radiance models feature capability to remotely
connect to the unit to obtain machine status
information such as product levels, total ounces and
number of drinks dispensed, current water temperature,
and dispenser status.
To log in, go to https://gmcw.kbfsm.com/.
Contact our customer service department for your
Username and Password.
If you need help, call Grindmaster-Cecilware Technical
Service Department, [phone] or [phone]
(USA & Canada only) (Monday through Friday 8 AM - 6
PM EST). Please have the model and serial number
ready so that accurate information can be given.
Wi-Fi Connection (continued) Grindmaster Connect™Operation
Username

Radiance Grindmaster Connect™Manual Cecilware®7
The Dashboards can be configured uniquely per
location, with multiple Dashboards if so desired.
In the upper left hand corner of the screen, select
“Manage Dashboards”
This will show you the Dashboards that are configured,
and allow you to create a new Dashboard or edit the
existing ones.
• Click the + key to add a new Dashboard.
• Click the pencil icon to edit an existing
Dashboard.
• Click the gear icon to configure the
Dashboard.
• Click the trash can icon to delete the
Dashboard configuration.
• If a Dashboard is not enabled it is not then
selectable via the Dashboard list dropdown.
The data elements that can be display are below. This
data can be displayed in various text or graph display
formats.
• Powder head status/overall machine status
• Water tank temperature/water status
• Product dispense detail
• Product dispense summary
In the customization screen each data element that is
displayed is displayed in its own widget. For each
widget you can set a custom title, color, widget size,
device being reported, days being reported, and
refresh rate for the widget.
After you made your configuration changes, press
“Save and Return” to view the results.
Customizing
Add new
Configure
Edit
Delete
Enable / Disable

Grindmaster-Cecilware
4003 Collins Lane, Louisville, KY 40245 USA
Phone: [phone] Toll Free: 800.695.4500
Fax: [phone]
Web: gmcw.com Email: [e-mail]
©2016 Grindmaster-Cecilware
Printed in USA
0816 Form # CW-322-01
Part # 390-00040
Customizing (continued)
Below is an example of a configured Dashboard.
If you need help, call Grindmaster-Cecilware Technical Service Department, [phone] or [phone] (USA
& Canada only) (Monday through Friday 8 AM - 6 PM EST). Please have the model and serial number ready so
that accurate information can be given.
Prior authorization must be obtained from Grindmaster-Cecilware for all warranty claims.
Grindmaster-Cecilware provides the industry’s BEST warranty. Visit our website at gmcw.com for
warranty terms and conditions.