CEI GAM40 User manual

Technical Manual
GAM40(& GAM40K,
GAM40B)
Underwater LED lighting
Réf : PK10R101 / PK10R105 / PK10R106
Table of Contents
1. Technical characteristics ........................................................................................................ 2
1.1. Packaging Contents ..................................................................................................... 2
2. Description ............................................................................................................................. 2
2.1. Trims ........................................................................................................................... 2
3. Installation ............................................................................................................................. 4
3.1. Placement of trim ........................................................................................................ 4
3.2. Installing In wall through (1.5" threaded) - 1,5" vacuum point .................................... 5
4. Electrical Connections ........................................................................................................... 6
5. Transformer Power ................................................................................................................ 6
6. Projector Protection ................................................................................................................ 6
7. Cable Cross-Section ............................................................................................................... 7
A. Connection schematic .......................................................................................................... 7
B. Declaration of conformity ................................................................................................... 8
Read these instructions carefully before installing, commissioning and using
this product.
MPNT0278 v2.0EN (08/03/2016)

Technical Manual GAM40(& GAM40K, GAM40B) v2.0EN
1. Technical characteristics
Dimensions Ø 172mm / breadth 91mm (without trim)
Installation On 1.5" vacuum point
Power supply Voltage: 12 V~ AC / Frequency: 50Hz/60Hz
Consumed power 44W
Weight 950g (projector only) / 1,2kg (with packaging)
LED type 96 MidPower monochrome LEDs
Risk group 1 (low risk) according to IEC62471:2006
IP Rating IP-68
Max light stream
PK10R101 (GAM40) 4400 lm max.
PK10R105 (GAM40K) 4400 lm max.
PK10R106 (GAM40B) Radiometric power:
13000mW max.
Floodlights must never be turned on outside of water.
1.1. Packaging Contents
1 BRIO GAM40 light with
• 2x0.75mm² cable: 3m (pre-assembled)
• Technical manual (this document)
2. Description
BRIO GAM40 LED light are designed to replace swimming pool projectors, traditionally equipped
with 300W PAR56 incandescent bulbs. They are installed exclusively in 1,5" vacuum outlet and
allow you to reduce your energy consumption and to light your swimming pool.
2.1. Trims
The GAM40 are supplied without trim, allowing the use of the trim of your choice;
www.c-
cei.fr 2

Technical Manual GAM40(& GAM40K, GAM40B) v2.0EN
Gaia
PF10R14L/W White RAL9003
PF10R14L/G Grey RAL7040
PF10R14L/S Sand RAL1015
PF10R14L/A Anthracite RAL7016
www.c-
cei.fr 3

Technical Manual GAM40(& GAM40K, GAM40B) v2.0EN
3. Installation
3.1. Placement of trim
The trim of your choice, not supplied with the GAM40 should clipped around the former as shown
in the following illustration:
Put a clip, then a second opposite of the first before clipping all ;
www.c-
cei.fr 4

Technical Manual GAM40(& GAM40K, GAM40B) v2.0EN
3.2. Installing In wall through (1.5" threaded) - 1,5" vacuum
point
BRIO LED GAM40(& GAM40K, GAM40B) lights should be installed in a
threaded 1.5" duct (vacuum point for example). We recommend that installa-
tion is performed by a professional. Please refer to the wall passage installation
instructions for placement.
www.c-
cei.fr 5

Technical Manual GAM40(& GAM40K, GAM40B) v2.0EN
4. Electrical Connections
Installation of this project involves a hazard of electric shocks. We strongly rec-
ommend you contract a professional installer. Incorrect installation places you
in danger and may irreversibly damage the product and the equipment con-
nected to it. In compliance with the NF C 15-100 standard, pool lights installed
in Volume 0 must always be powered by VLSV (Very low safety voltage). Al-
ways cut off the power upstream before handling the electrical installation.
Risk of electric shock. Only connect to a circuit which is protected by a 30mA
circuit-breaker. If you are not sure if these types of devices are fitted, contact
a qualified electrician.
Theelectricalconnectionmustbeperformeddry,
in a sealed connection box whose cable glands
must be tightened in order to avoid any water in-
filtration.
Once startup and the operation tests are complete, it is recommended to drown the connection with
a reusable soft hydrophobic insulating gel. (ref. CCEI PNSP0002)
The external flexible cables for these light fittings may not be replaced.
If a cable is damaged, the fitting must be destroyed or returned to the manu-
facturer for recycling.
5. Transformer Power
The transformer to be used must have a sec-
ondary voltage of 12V (12.5V depending on the
model). The power of the transformer must be in
line with the power of the lights to be connected.
In any case, the sum of the powers of the lights
must remain below or equal to the power of the
transformer.
Transformer Power Max no. of GAM40
50VA 1
100VA 2
300VA 6
Preferably use transformers sold in power supply units from the same manu-
facturer.
6. Projector Protection
Independent protection is necessary for each GAM40. Protection must be ensured in the secondary
of the transformer using fuses or breakers at 4A or more.
www.c-
cei.fr 6

Technical Manual GAM40(& GAM40K, GAM40B) v2.0EN
7. Cable Cross-Section
CROSS-SEC-
TION (mm²)
2.5 4 6 10
The voltage drop in the supply cable of the GAM40 cable
should be limited in order to comply with the applicable stan-
dards and ensure optimal illumination.
Follow the table opposite (one projector per cable); Max. length
(m) 10.0 17.0 25.6 42.6
A. Connection schematic
www.c-
cei.fr 7

Technical Manual GAM40(& GAM40K, GAM40B) v2.0EN
B. Declaration of conformity
Bleu Electrique SAS (FR47403521693) declares that product GAM40(&
GAM40K, GAM40B) is compliant with the safety and electromagnetic com-
patibility requirements of European directives 2006/95/CE and 2004/108/CE.
Emmanuel Baret
Marseilles, on 08/03/2016
Distributor's stamp
Date of sale: . . . . . . . . . . . . . . . . . . . . . . . Batch N°: . . . . . . . . . . . . . . . . . . . . . . . . . . .
www.c-
cei.fr 8