66
Zephiro Snow 1250 User Manual
Eng
to the machine.
yThe operation noise is without harm to ear. No need to wear ear protection
when close to the working machine.
2) Mounting and Rigging
yFor safety reasons, it is not recommended to mount the product on suspended
structures. Operate the product while it is on the ground only.
yThe product is for both indoor and outdoor use but, in order to prevent risk of
fire or shock, do not expose the product to rain or moisture
CAUTION: When transferring product from extreme temperature environments,
(e.g. cold truck to warm humid ballroom) condensation may form on the inter-
nal electronics of the product. To avoid causing a failure, allow product to fully
acclimate to the surrounding environment before connecting it to power.
yDo not use in a confined space. Always install the product in a location with
adequate ventilation, at least 20 in (50 cm) from adjacent surfaces.
yBe sure that no ventilation slots on the product’s housing are blocked.
3) Power and Wiring
yAlways make sure that the voltage of the outlet to which you are connecting
the product is within the range stated in paragraph “8 - Specification” on page
13 or rear panel of the product (AC220V- 50Hz).
yMake sure the power cord is not crimped or damaged. Never connect this prod-
uct to a dimmer pack or rheostat.
yNever disconnect the product from power cord by pulling or tugging on the cord.
yTo eliminate unnecessary wear and improve its lifespan, during periods of non-
use completely disconnect the product from power via breaker or by unplugging
it.
yTo avoid electric shock, all fixtures must be connected to circuits with a suitable
ground.
4) Water / Moisture
yThe unit should be protected from moisture and rain, and can not be used near
water; for example near a bathtub, a kitchen sink, a swimming pool, etc.
5) Heat
yThe apparatus should be located away from heat sources such as radiators,
stoves or other appliances that produce heat.
